Advertenties
Beschikbare talen
Beschikbare talen
WARNING!
Neglecting to follow the instructions in the manual could cause damages or injuries.
6 MAINTENANCE
6.1
Routine maintenance
WARNING!
•
Before carrying out any routine maintenance operation, put the ON/OFF button (11) in 'off' position and
remove the battery (16) from the tool.
•
All the maintenance operations which are not mentioned in this manual must be carried out at an Authorized
Service Point.
Routine maintenance operations can be carried out by the operators.
6.1.1
Chain tension adjustment
The chain (1) tends to expand or shrink while using the tool. This causes a change in its tension.
Periodically check the chain tension, adjusting it if necessary.
Do not tension the chain when it has stretched due to heat. Make any new adjustment only after its cooling.
Tension is correct when the chain perfectly fits the bar (2) lower part and can
still be easily further pulled along the bar with two fingers
The correct tension with a Carving bar is when the chain teeth are half visible
on the underside of the bar (2).
To adjust the chain tension, perform the following steps in sequence:
•
Switch off the tool by means of the ON / OFF button (10)
•
Remove the battery (16) by pressing on the releasing plates (17)
•
Loosen the nuts (3) by turning them anti-clockwise.
•
Turn the adjusting screw (4) clockwise by means of a screwdriver until the chain perfectly fits the lower part of the
bar and can be easily further pulled along the bar with two fingers.
•
Lock the nuts (3) by turning them clockwise.
Page. 38
Use and maintenance manual – Translation of
original Instruction.: 03, Date 16/12/2022
Advertenties
