Download Print deze pagina

Ryobi RDP102L Gebruikshandleiding pagina 20

254mm 10 kolomboormachine met laser

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 111
EN
FR
DE
ES
IT
NL
rEcoMMEnDED accEssoriEs
carton contEnts
unpacKinG anD cHEcKinG contEnts
Carefully unpack the drill press and all its parts, and
compare against the list below.
To protect the drill press from moisture, a protective
coating has been applied to the machined surfaces.
Remove this coating with a soft cloth moistened with
kerosene or WD-40.
3
Base
4
Rack
5
Column assembly
6
Rack ring
7
Feed handles
8
Worm gear
9
Table lock handle
10
Table crank handle
11
Hex bolts
12
Chuck
13
Chuck key
14
4 mm hex key
15
3 mm hex key
assEMBly anD aDjustMEnts
warninG
For your own safety, never connect plug to power
source outlet until all assembly steps are complete and
you have read and understood the safety and
operating instructions.
warninG
English
PT
DA
SV
FI
NO
RU
1
1
1
1
3
1
1
1
3
1
1
1
1
PL
CS
HU
RO
LV
LT
The drill press is a heavy power tool and should be
lifted with the help of two people or more to safely
assemble it.
assEMBlinG coluMn to BasE
See Figure 5.
1. Place the base on a flat, stable surface.
2. Align screw holes in the column assembly with
screw holes in the base.
3. Place a hex bolt in each hole.
4. Tighten each hex bolt using an adjustable wrench.
installinG taBlE to coluMn assEMBly
See Figures 6-10.
1. Insert the table bracket lock handle into the threaded
hole at the rear of the table bracket.
notE: Install the handle from left to right, so it enters
the non-threaded side of the table bracket first.
2. Feed the worm gear through the table crank hole in
the table bracket. Make sure the worm gear meshes
with
the inside gear.
notE: Do not remove the lubrication from the worm
gear.
3. Feed the rack through the slot in the table bracket
so that the teeth are facing out and the longer
smooth end faces up. The worm gear should
engage the rack.
4. Using both hands, slide the entire table and rack
onto the column until the bottom of the rack is
positioned in the base collar and against the column.
5. Tighten the table bracket lock handle to lock the
table assembly to the column.
notE: Do not overtighten.
6. Slide the rack ring, bevel-side down, over the
column until the beveled side engages the beveled
end of the rack.
7. Tighten the set screw in the collar using the hex key.
To avoid column or collar damage, do not
overtighten the set screw.
notE: You should be able to move the table from
side to side.
8. Install table crank handle over the end of worm gear
so that the flat side of the shaft aligns with the set
screw.
9. Tighten the set screw using the hex key.
The Drill Press head is heavy and should be lifted with
the help of two people to safely assemble the drill
press head on the column.
10
ET
HR
SL
SK
BG
UK
warninG
TR
EL

Advertenties

loading