Advertenties
Beschikbare talen
Beschikbare talen
disconnect the power cable. Then remove
the feed chute and eliminate the cause of
the fault.
8.8 Feeding the garden shredder
Risk of injury!
Carefully read the section entitled
"For your safety" ( 4.), sub-
section "Working with your
machine" ( 4.6) in particular, and
follow all the safety instructions
before feeding the garden
shredder. It is only permitted for
one person to feed the garden
shredder.
Risk of injury!
Never reach into the feed
opening.
● Before feeding the garden shredder,
note the working area. ( 8.4)
● Start the garden shredder. ( 10.3)
Soft material:
● Throw organic plant trimmings such as
fruit and vegetable waste, flower
cuttings, leaves, thin branches etc. into
the feed opening (1).
Damp or wet soft material will
cause blockages in the machine
more quickly. For this reason, feed
the garden shredder more slowly
and pay particular attention to the
motor speed. It should not drop
during feeding.
Hard material:
Cut up thick branches and
branches with side shoots (note the
maximum branch thickness
( 8.3)) beforehand using loppers.
0478 201 9913 D - EN
● Feed tree and hedge cuttings as well as
branch material slowly into the feed
opening (1). The hard material is
automatically drawn in by the machine.
Risk of injury!
The inclined blade unit can cause
8
branches to kick back.
In order to prevent injuries caused
by kickback, the garden shredder
must be fed with hard material in
the correct manner:
Insert longer branches at a slight
angle and guide them along the
right-hand chute wall to the blade
unit in accordance with the
symbol (2).
Observe the correct motor load.
( 8.5)
9. Safety devices
9.1 Motor restart inhibitor
The machine can only be started via the
switch and not by plugging the electric
cable into the mains socket.
9.2 Safety interlock
The motor/shredding tool may only be
operated when the feed chute has been
properly closed. If the right closure screw
(machine viewed from the front) becomes
loose during operation, the motor is
switched off automatically and after a few
seconds the shredding tool comes to a
standstill.
9.3 Motor run-down brake
The motor run-down brake shortens the
run-down time from when the machine is
switched off until the blades stop to a few
seconds.
9.4 Protective covers
The garden shredder is equipped with
protective covers in the feeding and
ejection areas. These include the
complete feed chute with the upper chute
and splash guard, the ejection chute
extension and the discharge flap.
The protective covers ensure that a safe
distance is maintained from the shredding
blades.
10. Operating the machine
Risk of injury:
Carefully read the section entitled
"For your safety" ( 4.) and follow
all the safety instructions before
operating the garden shredder.
10.1 Electrical connection of garden
shredders
Risk of injury!
Observe the instructions in section
"Warning – dangers caused by
electrical current" ( 4.2).
Power supply and operating voltage must
correspond (see rating plate).
The power cable must be adequately
protected by fuse in line with the
respective national electrical installation
regulations. ( 17.)
43
Advertenties
