Inhoudsopgave
Advertenties
ponding control knob turned to on and
it held at depressed position to allow
gas reach the injector.
3.
Apply prepared soapy water at the in-
jector connection with a small brush, if
there is leakage of gas at the injector
connection the soapy water will begin
to froth. In this case, tighten the in-
jector with a reasonable force and re-
peat step 3 process once again.
5 First Use
Before you start using your product, it is
recommended to do the following stated in
the following sections respectively.
5.1 Initial Cleaning
1. Remove all packaging materials.
2. Remove all accessories from the oven
provided with the product.
3. Operate the product for 30 minutes and
then, turn it off. This way, residues and
layers that may have remained in the
oven during production are burned and
cleaned.
4. When operating the product, select the
highest temperature and the operating
function that all the heaters in your
product operate. See "Oven operating
4.
If the froth still persist you must turn
off the gas apply to the product imme-
diately and call an Authorised service
agent or technician with licence. Do
not use the product until the author-
ized service has intervened in the
product.
functions [} 16]". You can learn how to
operate the oven in the following sec-
tion.
5. Wait for the oven to cool.
6. Wipe the surfaces of the product with a
wet cloth or sponge and dry with a
cloth.
Before using the accessories:
Clean the accessories you remove from the
oven with detergent water and a soft
cleaning sponge.
NOTICE: Some detergents or cleaning
agents may cause damage to the surface.
Do not use abrasive detergents, cleaning
powders, cleaning creams or sharp objects
during cleaning.
EN / 31
EN
NL
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
