Inhoudsopgave
Advertenties
5. You must check for leakage of the con-
nection part after connection.
Making the gas connection - LPG
• Your product should be connected in a
way that it will be close to the gas con-
nection to prevent gas leakage.
• Before making your gas connection,
provide a plastic gas hose and suitable
mounting clamp. The inner diameter of
the plastic gas hose must be 10 mm and
the length should not be longer than 150
cm. The plastic hose must be leak-proof
and inspectable.
• Gas appliances and systems must be
regularly checked for proper functioning.
Regulator, hose and its clamp must be
checked regularly and replaced within
the periods recommended by its manu-
facturer or when necessary.
• A new sealing gasket must be used while
making the gas connection.
• The gas connection must be made via a
gas hose or a fixed connection.
Connection with clamped (threadless) gas
hose
1. Place the new seal in the connection
piece for liquid gas and make sure the
seal is seated correctly.
2. Secure the gas connection outlet of the
product with a 22 mm spanner, connect
the connecting piece to the gas outlet
of the product with a 24 mm spanner
and tighten securely.
3. Fit the mounting clamp to one end of
the gas hose. Soften the end of the gas
hose to which you have attached the
clamp by placing it in boiling water for
one minute.
4. Insert the softened gas hose all the way
into the connection piece. Tighten the
clamp securely with a screwdriver.
5. You must check for leakage of the con-
nection part after connection.
Leakage check at the connection point
• Make sure that all knobs on the product
are turned off. Make sure that the gas
supply is open. Prepare soapy foam and
apply it onto the connection point of the
hose for gas leakage control.
• Soapy part will froth if there is a gas
leakage. In this case, inspect the gas
connection once again.
• Instead of soap, you can use commer-
cially available sprays for gas leak
check.
• If there is gas leak, shut off the gas sup-
ply and ventilate the room.
• Never use a match or lighter to make the
gas leakage control.
4.4 Placing the product
1. Push the product towards the kitchen
wall.
2. Secure the safety chain you have con-
nected to the product to the wall.
3. Adjust the feet of oven
Adjusting the feet of oven
Vibrations during use may cause cooking
vessels to move. This dangerous situation
can be avoided if the product is level and
balanced.
EN / 28
EN
NL
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
