Inhoudsopgave
Advertenties
cloth. Then dry with a clean cloth. Pay
attention that the spark plug and the
thermal element are completely dry.
5. Clean the burner caps and heads with
detergent water after each operation
and then dry them.
6. For persistent stains, keep burner caps
and heads in detergent water or warm
soapy water at least for 15 minutes.
Clean with a non-metallic and non-
scratching brush.
7. You may use the Quick&Shine cleaning
agents for the oven interiors and grills,
used on enamelled surfaces and re-
commended by the authorized service,
especially for persistent stains on
enamelled burner caps.
8. Do not contact burner caps with ag-
gressive detergents such as oven in-
terior cleaning agents, descalers while
cleaning them, this may cause discol-
ouration.
9. Clean the pot holders with detergent
water and non-scratching, soft brush
after each operation and then dry them.
10.When the burner caps and pot holders
are used as wet, persistent lime stains
may occur as a result of the heat. En-
sure that it is dried before operation.
11.Place burner heads, caps and pot hold-
ers respectively.
12.When placing the pot holders, ensure
that they centre the burners. In pin
models, fit the pins on the burner plate
to the pin slots on the pot holders.
Assembling the burner parts
1. Place the parts as in the figure after
cleaning the burners.
2. Place the burner head ensuring that it
passes through the burner spark plug
(4). Turn the burner head right and left
to make sure that it is seated in the
burner chamber.
3. Place the burner cap on the burner
head.
1
Burner cap
2
Burner head
3
Burner chamber
4
Spark plug (in models with ignition)
9.3
Cleaning the Control Panel
• When cleaning the panels with knob-
control, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
Do not remove the knobs and gaskets
underneath to clean the panel. The con-
trol panel and knobs may be damaged.
• While cleaning the inox panels with knob
control, do not use inox cleaning agents
around the knob. The indicators around
the knob can be erased.
• Clean the touch control panels with a
damp soft cloth and dry with a dry cloth.
If your product has a key lock feature, set
the key lock before performing control
panel cleaning. Otherwise, incorrect de-
tection may occur on the keys.
9.4
Cleaning the inside of the oven
(cooking area)
Follow the cleaning steps described in the
"General Cleaning Information" section ac-
cording to the surface types in your oven.
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls.
It varies by model. If there is a catalytic
wall, refer to the "Catalytic surfaces" sec-
tion for information.
EN / 43
EN
NL
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
