Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7. O P E R AT I N G T H E V O L C A N O H Y B R I D
approx. 5 sec
Preheat plant material for a few seconds
7.6. EASY VALVE Balloon
7.6.1. Application
When the actual temperature
corresponds to the set tem-
perature, tighten the Valve Bal-
loon, place it on the Filling Chamber
and let it lock in place.
Stretch Valve
Balloon tight
Báó ¼ P PMéc 1vp VlP7p OlPPááé 41léF4
vertically on the Hot Air Generator. This
will open the Valve. Press the touch
button labeled 'AIR'. Now the Valve Bal-
Pááé2MPP¼ P P2M1v7lzáó
AéP3¼ P P1vpVlP7pOlPPááé2M1v1vplz-
proximate amount of vapor that you in-
tend to use within the next 10 minutes.
Záéá1¼ P P1vpVlP7pOlPPááé.á,zPp1pP3
(overpressure) in order to prevent the
loss of vapor. It is important to observe
the vapor density in the Valve Balloon
4pp Rvlz1pó îBl.1áó4 Mé½ ü pé.Méc
Vaporization", page 59).
Watch vapor density
WkÜ&YkÜN.LyÜs.LLbb&oV¼ L LÜKV,oYOk
off the pump by tapping the touch
button pump (AIR) again - and remove
the Balloon together with the Filling
Chamber. To do this, grasp the Filling
Chamber Cap by the rotating knobs
and unscrew counterclockwise.
71
ok
Advertenties
Hoofdstukken
Inhoudsopgave
