Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7. O P E R AT I N G T H E V O L C A N O H Y B R I D
7.1. Installation
Do not leave the device unat-
tended during operation. Put
the VOLCANO HYBRID on a
½ l 1léF41lwPp4üógl.p
the mains voltage corresponds to the
voltage rating stated on the device.
The Power Cord and the power plug
must be in perfect condition. Only con-
nect the VOLCANO HYBRID to a prop-
erly installed socket.
When the power plug is plugged in,
all sequences of the LCD display light
üz wóMp½ 3 lg1pó 2vM.v 1vp ¼ ó ,2lóp
number is displayed. The mains sup-
ply indicator, which then appears on
the display, indicates that the Hot Air
Generator is connected to the mains
supply.
Check whether
66
7.2. Heating Up
Place the Filling Chamber with cap on
the Hot Air Generator and screw it on
clockwise as far as it will go. To turn
on the heater, press the touch button
'HEAT'. The set/actual temperature
will light up, signaling that the heater
is switched on. The upper, orange dis-
play shows the actual temperature in
the Filling Chamber, the lower, white
display shows the desired set tem-
perature. The heating process is com-
pleted when the set value is equal to
the actual value. This is also indicated
l.áü41M.lPP3w3wóMp½ 3 42M1.vMécáé1vp
pump (can be switched off using the
app). Depending on the set tempera-
ture, heating-up can take up to two
minutes. After the heating process is
completed, the temperature is con-
stantly maintained at the set value.
For technical reasons the
temperature in the Filling
Chamber cannot be mea-
sured during vaporization. During op-
eration the temperature is measured
at the heat exchanger. The display in-
dicates the reference values for the
attached Filling Chamber with the
pump switched on.
Advertenties
Hoofdstukken
Inhoudsopgave
