Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
If necessary, check the direction of rotation of the pump, as
described under 6.4. Put the switch on the control box to
the required mode of operation.
9. Maintenance and Repair
Before maintenance or repair disconnect the pump
from the power supply to avoid accidental starting of the
pump!
Before carrying out maintenance and service, the pump
must be thoroughly flushed with clean water. Rinse the
pump parts in clean water after dismanteling.
In case of a defect of the pump, a repair shall be car-
ried out only by the manufacturer or through an authorized
workshop. Conversions or alternations of the machine/unit
are permittes only after arrangement with the manufacturer.
Only HOMA spare parts shall be used.
In accordance with the product liability law we point out
that we shall not be liable for damages caused by our pro-
duct due to unauthorized repair by persons other than the
manufacturer or an authorized workshop or due to the use
of spare parts other than original HOMA parts. The same
product liability limitations are valid for accessories.
When unscrewing the inspection screw of the oil cham-
ber, please note that pressure may have built up in the
chamber. Do not remove the screw until the pressure has
been fully relieved.
Before maintenance or repair make sure that all rota-
ting parts stand still!
Pumps running under normal operation conditions should
be inspected at least once a year. If the pumped liquid is
very muddy or sandy or if the pump is operating conti-
nuously, the pump should be inspected every 1.000 opera-
ting hours.
When the pump is new or after replacement of the shaft
seals, check the oil level after one week of operation.
For long and trouble-free operation of the pump, following
points should be checked regularly:
- Nominal current (A): Check with amp-meter.
- Pump parts: Check for possible wear. Replace defective
parts.
- Ball bearings: Check the shaft for noisy or heavy operation
(turn the shaft by hand). Replace defective ball bearings. A
general overhaul of the pump is usally required in case of
defective ball bearings or poor motor function. This work
must be carried out by an authorized service
workshop.
- Cable entry: Make sure that the cable entry is watertight
and that the cables are not bent sharply and/or pinched.
- Oil level and oil condition in oil chamber: The oil becomes
greyish white like milk if it contains water. This may be the
result of defective shaft seal. The oil should be replaced
after 3000 operating hour. Oil type: Shell Tellus
C22, degradable HOMA-Atox available on request.
- Mechanical seals: Check the mechanical seals for wear-
out.
13
Advertenties
Hoofdstukken
Inhoudsopgave
