Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible more
than one in the same cycle) may prolong the
programme duration by another 5 minutes
when it occurs at any point at the beginning
or in the middle of a programme.
All the consumption values
mentioned in this section are determined
in line with the currently applicable
standard in laboratory conditions with
water hardness 2.5mmol/L (water
softener: level 3) according to the
regulation: 2019/2022 .
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
How to set the water softener level
The appliance must be in programme
selection mode.
Make sure that the programme marker on the
knob is in the on/off position.
1. To enter the user mode, press and hold
. At the same time turn the knob
counterclockwise until the programme
marker indicates the first programme.
Release the
and on/off start flashing.
The intermittent flashing of
current setting, e.g. 5 flashes + pause + 5
flashes = level 5.
2. Press
repeatedly to change the
setting. Each pressing of
the level number. After reaching level 10,
the count starts again from level 1.
3. To confirm the setting, turn the
programme knob until the programme
marker is again in the on/off position
6.3 The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically
released during the final rinse.
When the rinse aid chamber is empty, the
rinse aid indicator turns on. If the drying
results are satisfactory while using multi-
when the indicators
shows the
increases
tablets only, you can deactivate the
notification for refilling the rinse aid. However,
for best drying performance, always use rinse
aid.
If standard detergent or multi-tablets without
rinse aid are used, activate the notification to
keep the rinse aid refill indicator active.
How to deactivate the rinse aid
empty notification
The appliance must be in programme
selection mode.
Make sure that the programme marker on the
knob is set to the on/off position.
1. To enter the user mode, press and hold
. At the same time turn the knob
counterclockwise until the programme
marker indicates the first programme.
Release
when the indicators
on/off start flashing.
2. Turn the knob counterclockwise until the
programme marker indicates the second
programme.
The indicator
shows the current setting:
•
is on = the rinse aid empty
notification is activated.
•
is off = the rinse aid empty
notification is deactivated.
3. Press
to change the setting.
4. To confirm the setting, keep turning the
programme knob until the programme
marker is back in the on/off position.
6.4 AirDry
AirDry improves the drying results with less
energy consumption. The appliance door
opens automatically during the drying phase
and remains ajar.
and
ENGLISH
35
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
