Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Avoiding the danger of injury
and/or damage to property!
While working with your angle
grinder always wear protective
glasses, hearing protection and
safety gloves, and if necessary a hairnet
(with long hair) and a dust mask (depending
on the materials being cut).
Do not wear loose clothing while you are
working with your product.
Fasten the product through the fastening
holes down on to a workbench/table.
Ensure that the workbench/table and the
product are stable.
The eye protection must be capable of
stopping flying debris generated by various
operations. The dust mask or respirator must
be capable of filtrating particles generated
by your operation. Prolonged exposure to
high intensity noise may cause hearing loss.
m
WARNING! DANGER OF INJURY!
Ensure that you do not come into contact
with the cutting disc while working.
Always use the cutting disc safety guard
Use this product only with angle grinders
that have a suitable metal protective guard
around the disc (Fig. 7).
Position this protective guard on the grinder
in such a way that the lower part of the
rotating cutting disc is uncovered and the
grinder's protective guard cannot come into
contact with the workpiece.
WARNING! DANGER OF
FIRE! Cutting metal creates
sparks. Ensure that there are no
ignitable materials in the working area.
Sparks can damage paint, glass and other
surfaces. Do not wear clothing made of
nylon or polyester; wear suitable, non-
inflammable working clothes.
Ensure that the workpiece is held firmly in
place and lies tightly against the base plate.
Do not use the product on workpieces that
are too large, otherwise they cannot be held
firmly in middle of the vice.
10 GB/IE/NI
Check before and regularly during use that
the screws, bolts and other fixings are firmly
seated.
Check the product regularly for damage.
Vibrations can loosen screws, bolts and
other fixings during use.
Never use your product if you discover that it
is damaged in any way.
Ensure that the cutting disc of your angle
grinder is mounted at right angles to the
base plate.
Use cutting discs only and not roughing
discs in this product.
Check the cutting disc of your angle grinder
regularly for damage.
Never use a disc if you discover it has
any dents, nicks or other damage. It could
disintegrate.
Do not allow parts of your body to come
within working range of the cutting disc until
after it has come to a standstill.
When cutting follow the instructions of the
manufacturers of the electrical power tool
and the cutting disc.
Use angle grinders that have a cutting disc
5 ]
[
diameter of 125 mm only.
Do not allow anyone else to come
within the working range of the
product while you are using it.
Grip the handle tightly when using the angle
grinder and position your body and arm to
allow you to resist kickback forces.
Do not "jam" the wheel or apply excessive
pressure. Do not attempt to make an
excessive depth of cut. Overstressing
the wheel increases the loading and
susceptibility to twisting or binding of the
wheel in the cut and the possibility of
kickback or wheel breakage.
Advertenties
Hoofdstukken
Inhoudsopgave
