Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
NOTE
A damaged dust protection cap
u
be replaced immediately . Contact a
customer service workshop .
˜ Fitting an SDS tool
1 . Grease the SDS-Plus tool holder
with drill chuck grease
the tool .
2 . Insert the tool rotatingly into the SDS-Plus tool
holder
until it clicks into place .
[
12 ]
3 . Check that the tool is properly locked by
pulling it . The system has radial play because
of the design .
˜ Removing an SDS tool
Pull the locking collar
o
remove the tool .
˜ Selecting operating mode
Press and hold the release button
o
mode selection knob
selection knob so that the arrow mark points
to the corresponding symbol .
Symbol
Operating mode
Drilling
Hammer drilling
Chiselling
Adjusting chisel position
Adjusting chisel position
In order to rotate the insertion tool to the required
position for chiselling, proceed as follows:
1 . Turn the mode selection knob
(adjusting chisel position) .
14 GB/IE/NI
must
11 ]
[
slightly
[
12 ]
before inserting
20 ]
[
backwards to
13 ]
[
on the
[
8 ]
. Turn the mode
9 ]
[
to
9 ]
[
2 . Turn the insertion tool in the SDS-Plus tool
holder
into the required position .
[
12 ]
3 . Turn the mode selection knob
(chiselling) .
˜ Setting the rotation direction
NOTE
Operate the rotation direction switch
u
only when the product is at a standstill .
Use the rotation direction switch to change
o
the direction of rotation of the power tool . This
is not possible while the on/off switch
pressed in .
Clockwise: Push the rotation direction switch
o
to the left as far as the stop .
Anti-clockwise: Push the rotation direction
o
switch to the right as far as the stop .
˜ Switching on/off
Insert the mains plug
o
The LED
lights up to indicate that the
[
6 ]
product is ready for use .
Switching on
Press the on/off switch
o
Do not switch the power tool on unless you
o
plan to use it, to save energy .
Switching off
Release the on/off switch
o
At low temperatures, the power tool will only
o
reach its full hammer performance/strike
power after a certain time .
Continuous operation
Press the on/off switch
o
press the lock button
switch .
To cancel continuous operation, press the on/
o
off switch
and release it .
[
3 ]
to
[
9 ]
[
2 ]
is
[
3 ]
into a socket-outlet .
[
5 ]
.
[
3 ]
.
3 ]
[
. At the same time,
[
3 ]
to lock the on/off
[
4 ]
Advertenties
Hoofdstukken
Inhoudsopgave
