Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
SDS-Plus insertion tool
o
Suitable personal protective equipment
o
Accessories and accessory tools are available
through your authorised dealer . When buying
always consider the technical requirements of this
product (see "Technical data") . If you are not
certain, ask a qualified specialist and get advice
from your trusted dealer .
˜ Operation
m
WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments, cleaning and when not
in use .
m
WARNING!
Secure or fasten the workpiece during
u
drilling operations by using a clamp,
lockable pliers or a vice . Only perform
drilling works to a workpiece that is
securely fastened .
NOTE
Push the rotation direction switch
u
the middle position before carrying out any
work on the power tool (e .g . maintenance,
tool-changing, etc .) as well as during
carriage and storage of the power tool .
Unintentional activation of the on/off
switch
can result in injury .
3 ]
[
˜ Installing the auxiliary handle
NOTE
For safety reasons, only use this product
u
with the auxiliary handle
1 . Loosen the strap on the auxiliary handle
by turning it anticlockwise .
2 . Turn the auxiliary handle
angle depending on your working position .
into
2 ]
[
attached .
10 ]
[
10 ]
[
into a proper
10 ]
[
3 . Turn the auxiliary handle
tighten it .
˜ Installing the depth stop
1 . Loosen the depth stop screw
2 . Insert the depth stop
handle
.
[
10 ]
3 . Pull the depth stop
between the tip of drilling tools and the tip of
the depth stop corresponds with the required
drilling depth .
4 . Tighten the depth stop screw
depth stop
.
[
14 ]
˜ Selecting a tool
Application
Hammer drilling
Chiselling
Standard drilling
in wood, metal,
ceramics and plastic
˜ Tool-changing
Use the SDS-Plus tool holder
o
tools quickly and easily without the need for
any additional tools .
The SDS-Plus drilling tool moves freely
o
(depending on the system) . This leads to a
radial run-out deviation while idling . This has
no effect on the accuracy of the drill hole as
the drill centres itself during drilling .
The dust protection cap
o
the entry of drilling dust into SDS-Plus tool
holder during operation . Ensure that the dust
protection cap does not get damaged when
fitting tools .
clockwise to
[
10 ]
.
[
1 ]
into the auxiliary
14 ]
[
out until the distance
[
14 ]
to lock the
1 ]
[
Tool
SDS-Plus insertion tool
Appropriate SDS-Plus
drilling tool
to change
12 ]
[
largely prevents
[
11 ]
GB/IE/NI
13
Advertenties
Hoofdstukken
Inhoudsopgave
