Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
NOTE
The on/off switch
u
the ON position .
(Fig . I)
Switching on
1 . Push the switch lock
side to release the switch lock .
2 . Press and hold the on/off switch
3 . Regulate the speed as required (see "Speed
control") .
Switching off
1 . Release the on/off switch
2 . The switch lock
[
5 ]
original position .
˜ Speed control
Control the speed progressively with the on/
o
off switch
:
[
6 ]
Pressure
Gentle
Strong
˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every saw
blade replacement .
Switch the product off immediately if the
u
saw blade is not running smoothly, if
considerable vibration occurs or if you
hear abnormal noises .
˜ Working instructions
m
CAUTION! Risk of injury and
damage to property!
Wear protective gloves when handling
u
the saw blade
10 ]
[
injury from cuts .
cannot be locked in
[
6 ]
in on the left or right
5 ]
[
.
[
6 ]
.
6 ]
[
moves back into the
Speed
Lower speed
Higher speed
. In this way, you avoid
m
CAUTION! Risk of injury and
damage to property!
Do not use any blunt or bent saw blades
u
or saw blades which are damaged in any
other way .
Before sawing the workpiece, check for
u
hidden foreign objects such as nails and
screws and remove them .
Always insert a suitable saw blade .
u
Secure the workpiece with the aid of
u
clamping devices on the workbench .
Apply only as much pressure as is
u
required for sawing . If there is excessive
pressure, the saw blade may bend and
break .
Switch the product off immediately if the
u
saw blade jams . Try to spread the saw cut
and carefully pull the saw blade out .
Always stand to the side of the product
u
when working .
Always make sure that the workplace is
u
well ventilated .
Avoid over-stressing the product while
u
working .
Saw the material at a constant speed .
u
˜ Regular cuts
1 . Verify the saw blade
workpiece .
2 . Switch the product on .
3 . Apply the base plate
4 . Use even pressure, advancing at a steady
pace when making the cut .
You can make horizontal, diagonal, or
vertical cuts .
5 . When you are finished:
–
Switch the product off .
–
Pull the saw blade
workpiece .
is not touching the
10 ]
[
to the workpiece .
4 ]
[
out of the
10 ]
[
GB/IE/NI
17
Advertenties
Hoofdstukken
Inhoudsopgave
