Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION INSTRUCTION
PREPARING THE WATER HOSE AND THE
ELECTRICAL CONNECTION
Inspect all water connections for leaks. Water leaks can
cause significant damage over time. It is recommended to
use a 6.4 mm (1/4") water line with a minimum length of 1.5
metres (60") with a threaded 6.4 mm (1/4") female
connector end. Before finishing the installation, turn the
water on to ensure that water is flowing and that there are
no leaks.
A connector that has a thread with an external diameter of
6.4 mm (1/4") must be used to connect the end of the hose
to the product.
Allow for sufficient slack in the water supply line, providing
a minimum of 254 mm (10") of length from the base of the
unit once it is installed in the niche. This provides some
allowance for connections and adjustments if needed.
The product must be connected to a 2-prong outlet on a
dedicated 15 amp circuit; local electrical and building codes
should be respected.
You can choose method A or method B below to prevent
the power cord from getting wedged in.
•
Method A: Position the water hose and the mains power
connections on the back.
A
•
A Water line location
•
B Power cord location
26
•
B
Fig. 22
Method B: Position the water hose and mains power
connections on the side.
A
B
•
A Keep open for water line
•
B Water hose
•
C Keep for power cord
C
Fig. 23
Advertenties
Hoofdstukken
Inhoudsopgave
