Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION INSTRUCTION
•
For the most secure installation, use a stud-finder to
secure the anti-tip brackets in wall studs. If no studs are
present at the correct installation location, follow the
instructions below.
WARNING
Always make sure that the area to be
drilled into is free of any waterlines or
electrical circuits, which could cause
damage, injury, or death.
•
Use a drill to create holes for wall anchors (#2) at the
marked points 7.9 mm (5/16" Ø), 8 mm).
•
Use a hammer to install the wall anchors (#2) if no stud
is present.
24
•
Install the brackets (#1) in place, using 4 screws for
each.
•
You must use both (two) brackets to ensure that the
appliance is safely supported.
•
A Thickness
NOTE
If you are not confident that the supplied
connectors and anti-tip brackets are
mounted on the wall as securely as they
Fig. 18
should be, you can use alternative anti-
tip methods.
If there is a cabinet panel behind the
back wall of the refrigerator, make sure
that it is securely fastened to the wall.
For this, you need to be sure that the
back wall of the cabinet panel is affixed
to a wall stud.
Alternative anti-tip method:
If the anti-tip brackets cannot be mounted securely, you
must use the alternative method below. For this method,
you can use wooden boards to avoid the risk of tipping
over.
They must be installed as illustrated in the figure below.
There must be no clearance between the appliance and the
wooden support.
Fig. 19
A
Fig. 20
Advertenties
Hoofdstukken
Inhoudsopgave
