Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PLUMBING REQUIREMENTS
Models equipped with an Ice Maker and/or a Water
Dispenser require a connection to the domestic water
supply system.
NOTE
Take the necessary measures to prevent
the risk of freezing of the hoses. The
operating water temperature range is
between a minimum of 1℃ (34℉) and a
maximum of 38℃ (100℉).
The system pressure must be:
•
Min. 0.17 Mpa (1.7 bar, 25 psi)
•
Max. 0.55 Mpa (5.5 bar, 80 psi)
Any pressure outside of this range may cause the water
system to malfunction or leak. If the water pressure
exceeds the maximum value, install a pressure limiting
valve to your mains system. If the water mains pressure is
lower than the minimum value, it is possible to use an
auxiliary pump.
If you do not know how to check the water pressure, please
consult a professional plumber.
WARNING
This appliance should only be connected to
a drinking water system.
WARNING
The location of the water line connection
must be within the area shown in the figure
below.
WARNING
The refrigerator's water system must be
connected to the house's main water
supply.
WARNING
The user must be able to switch it on/off
using the valve when necessary.
WARNING
Make sure that installation is performed
correctly and in accordance with all the
instructions in the specific installation
manual provided with the appliance.
WARNING
Do not attempt to use a locally sourced
threaded garden hose adapter or braided
supply line. It will strip the threads on the
appliance's water connection solenoid.
NOTE
A bypass plug is recommended for the
water filtering system if a reverse osmosis
system is used.
WARNING
Make sure that there is no water leakage
when establishing the water connections.
Otherwise,
cabinetry. The water supply line must
located in the cabinet where the appliance
is to be installed. The user must be able to
switch it on/off using the valve when
necessary.
You will need a hose with a minimum length of 1.5 m (60")
and a diameter of 6.4 mm (¼") for the appliance's water
connections during installation. A connector that has a
thread with an external diameter of 6.4 mm (¼") must be
used to connect the end of the hose to the product.
Before completing the installation, make sure that water
flows and that there is no water leakage.
A
•
A 50.8 mm (2")
•
B 254 mm (10")
•
C 102 mm (4")
•
D 6 mm (1/4")
water
may
damage
B
C
D
the
Fig. 8
15
Advertenties
Hoofdstukken
Inhoudsopgave
