Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ELECTRICAL REQUIREMENTS
The location of the electrical outlet in the cabinet where the
product is to be installed must be within the area shown in
the figure.
CAUTION
Do not use extension cords or two-prong
adapters and do not remove the ground
terminal of the grounding cable.
CAUTION
A qualified electrician must ensure that the
poles of the socket are connected correctly.
Verify that the grounding of the socket is
correct.
B
A
•
A 102 mm (4")
•
B 127 mm (5")
•
C 280 mm (11")
•
D 50.8 mm (2")
WARNING
Do not connect the appliance to electronic
energy saver plugs.
The socket must comply with the following data:
ELECTRICAL REQUIREMENTS
Plug type
Power cord
Voltage
Frequency
Fuse
14
D
C
SCHUKO
2-prong
220 V – 240 V
50 Hz
15 A
After installation, wait at least 3 hours before connecting
the appliance to the electrical power to avoid damaging the
compressor.
IMPORTANT
Do not use extension cords and/or multiple
adapters for the power supply connection.
If the electrical wiring or the electric power supply of the
house requires alteration, the necessary procedures must
be performed by a qualified electrician.
Please heed the following rules:
•
The electrical outlet or panel must be easily accessible
in case of an emergency; it must not be hidden behind
the product.
•
Neither the plug nor the cable may touch the back
surface of the appliance. Otherwise, it may be damaged
by the appliance's vibrations.
•
Do not connect other equipment plugs behind this
appliance. If the humidity level is high where the
appliance is being used, its exterior surfaces may
become corroded. To prevent corrosion, keep the
installation room dry and well-cleaned.
To prevent the risk of electric shock:
•
Connect the plug to a grounded outlet.
•
Do not remove plug's grounding prong.
•
Do not use adapters.
•
Do not use extension cords.
Fig. 7
CAUTION
Do not connect the grounding cable to the
gas line. Please have the grounding
checked by a qualified electrician if you are
not sure about the grounding of the
appliance. Do not install a fuse on the
neutral line or on the grounding circuit.
CAUTION
Failure to follow these instructions may
result in fire, electric shock or death.
Connecting
conductor in the wrong place may lead to
electric shock. Please have the grounding
checked by a qualified electrician or service
technician if you have any doubt about the
proper
Installation, repairs and other procedures
performed by unqualified persons may give
rise to hazards. Before installing the
appliance, make sure that the voltage, load
and circuit current parameters on the data
plate are in compliance with the power
supply in your house.
the
appliance's
grounding
of
the
grounding
appliance.
Advertenties
Hoofdstukken
Inhoudsopgave
