Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Main broom replacement
–
Remove the right side lid screw.
–
Remove the right side lid.
–
Remove the mounting screws and the seal holders.
–
Move the seal sideways.
–
Remove the split pin (1, Fig. S).
–
Remove the support (2, Fig. S).
–
Remove the broom (3, Fig. S).
–
Install the new broom (3, Fig. S).
–
Install the support (2, Fig. S).
–
Reinstall the split pin (1, Fig. S).
–
Reinstall the seal and the seal holders.
–
Close the lid.
Main broom (print on ground) adjustment
If the main broom is left rotating for a few minutes when the
machine is stationary, the print left on the ground is useful to
adjust the broom itself.
–
If the print size is less then 40 mm or more than 100 mm,
adjust the spring pressure with the mounting screw (1,
Fig. T).
Side broom replacement
–
Unscrew the mounting screw and remove the broom.
–
Unscrew the support mounting screws.
–
Replace the broom and reinstall the mounting screws.
–
Secure the broom to the motor.
Side broom adjustment
–
Adjust the broom pressure with the setscrew (1, Fig. U).
Rear seal replacement
–
The seal should touch the ground lightly and evenly.
–
To replace the seal, remove the mounting nuts (1, Fig.
V).
–
Remove the seal holder.
–
Replace the seal and reinstall.
Closed pocket filter replacement
–
Open the hopper hood (1, Fig. W).
–
Unscrew the cover screws (1, Fig. X).
–
Remove the cover (1, Fig. Y).
–
Remove the mounting bars by unscrewing the screws
(1, Fig. Z).
–
Remove the filter (1, Fig. AA).
–
Disconnect the filter shaker cable (1, Fig. AB).
–
Replace the filter.
–
Reconnect the filter shaker.
–
Reinstall the filter (1, Fig. AA) in the hopper.
–
Reinstall the mounting bars.
–
Screw the mounting screws (1, Fig. Z).
–
Reinstall the cover (1, Fig. Y).
–
When installing the filter, make sure that the cover
gasket is air-tight and that the filter is positioned
correctly.
Machine releasing
To tow the machine, release the hydrostatic transmission by
turning the screw (1, Fig. AC) counterclockwise.
33014812(1)2005-07 A
DISMANTLING, DISPOSAL
NOTE
Material should be disposed according to the
law in force.
DISMANTLING
NOTE
Pay the greatest attention when disconnecting
the conductors which are live even when the
ignition switch is in the "0" position.
Disconnect the cables from the control panels paying
attention to the markings on each cable and referring to the
wiring diagrams.
Do not remove the reference numbers from the cables and
terminal boards.
Hydraulic system dismantling
Dismantle the hydraulic systems referring to the relevant
diagrams.
Mechanical dismantling
Before the machine mechanical dismantling, wash all parts
that come into contact with the material and thoroughly clean
the rest of the machine.
Refer to the chapter "Transportation" for lifting the machine
and safety precautions to be taken.
Packaging
Use packing material suitable for the part weight and
features.
NOTE
Secure a plate to the packaging showing
weight, content and any other information
necessary for transportation.
USER MANUAL
15
Advertenties
Hoofdstukken
Inhoudsopgave
