Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USER MANUAL
PERIODICAL CHECKS
Battery
WARNING!
Wear gloves and goggles.
Check the electrolyte level.
Check the battery poles for oxidation.
Clean the entire surface of the battery with a damp sponge.
Tyre pressure
Recommended pressure: 7 Bar
Fluid levels
Brake fluid:
DOT4
Hydraulic oil: AGIP Arnica 46
Engine oil:
AGIP Sigma
(HD series 3 MIL - L 2104-C - API - CD)
Coolant level
Mixture:
50% AGIP antifreeze and 50% water
Skirt closing adjustment
–
Loosen the locknut (1, Fig. J).
–
Adjust the fastener, making sure that the skirt closing
panel closes hermetically.
–
Adjust the skirt spring (2, Fig. J) pressure with the
mounting nut.
Parking brake adjustment
–
Loosen or pull the nut (1, Fig. K) avoiding to move the
cable end.
–
Adjusting the cable tension, make sure the brake is not
locked.
Air cleaner replacement
–
Unscrew the mounting screw (1, Fig. L) and remove the
cover.
–
Unscrew the air cleaner (2, Fig. M) setscrew (1).
–
Remove, clean or replace the air cleaner.
–
Reinstall the cover and tighten the screw.
14
Gear pump hydraulic oil filter replacement
–
Remove the tank cover (1, Fig. N).
–
Empty the tank by means of a pump.
–
Unscrew the filters (1, Fig. O) from their seats inside the
tank.
–
Screw the new filters into place using the appropriate
wrench and reinstall the tank cover.
–
Screw the drain plug.
–
Check the oil level and top it up if necessary.
WARNING!
Do not pollute the environment with used oils
and filters.
Variable delivery pump hydraulic oil filter
replacement
Unscrew the filter (1, Fig. P) and place it in a container for
special waste. Replace it with an original filter.
WARNING!
Do not pollute the environment with used oils
and filters.
EXTRAORDINARY MAINTENANCE
WARNING!
Any maintenance operation should be carried
out with the machine off.
Wait for all the parts to stop and cool down.
For the engine maintenance, please follow the instructions
provided in the Use and Maintenance Manual concerning the
engine installed on the sweeper. This manual comes in a
special case.
Left side seal replacement
–
Remove the mounting screws (1, Fig. Q) and the seal
holders (2).
–
Fit the new seal with the seal holders, so that the seal
slightly touches the ground.
–
Tighten the mounting screws.
Right side seal replacement
–
Unscrew the engine hoses (1 Fig. R).
–
Unscrew the main broom arm (4, Fig. R).
–
Remove the mounting screws (3, Fig. R) and the seal
holders (2).
–
Fit the new seal with the seal holders, so that the seal
slightly touches the ground.
–
Tighten the mounting screws.
33014812(1)2005-07 A
Advertenties
Hoofdstukken
Inhoudsopgave
