Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5.3.6 Programming auto heat up
All cooking zones are equipped with an auto heat up function.
The cooking zone will initially operate at full power for a certain
amount of time before automatically reducing to the selected
power level.
Programming auto heat up:
Activating auto heat up
Glide your finger over the slider to (for example)
7
and hold for 3 seconds
Switching auto heat up off
Glide your finger over the slider
Auto heat up table
Set value for cooking time
1
2
3
4
5
6
7
8
9
5.3.7 Stop & Go function
This function temporarily interrupts the activity of the hob and
allows a restart with the same settings.
Turning Stop & Go on and off:
Switching on
II
Press
Switching off
II
Press
Then press the animated slider
5.3.8 Recall function
After turning the hob off
to recall the last selected settings: (this up to a maximum of 10
seconds)
– State of all cooking zones (power)
– Minutes and seconds of the programmed cooking zones by
the timers
– "Automatic cooking" function
– Keep warm function
The recall procedure is as follows:
– Push the control key
II
– Push
before the flashing stops.
The previous settings are now active again.
Display
7 A
Display
0
9
to
0‐9
Auto heat up function
Time (min:sec)
0:40
01:12
02:00
02:56
04:16
07:12
02:00
03:12
--:--
Display
I I
0‐9
, it is possible
5.3.9 Keep warm function
This function makes it possible to automatically reach and
maintain a temperature of 42°C, 70°C or 94°C.
This prevents pans overflowing or your food sticking to the
bottom of the pans.
Switching the keep warm function on and off:
Keep warm 42°
Press [Keep warm control key] once
Keep warm 70°
Press [Keep warm control key] twice
Keep warm 94°
Press [Keep warm control key] 3 times
Switching the keep warm function off
Glide your finger over the slider
or press [ Keep warm control key ] until [ 0 ]
The maximum duration of the keep warm function is 2 hours.
5.3.10 Bridge function
This function allows you to link the 2 left and 2 right zones so
they operate as 2 large zones. This function can be activated
manually, or automatically should a large pot/pan be placed on
the cooking surface.
Manual activation
Simultaneously press [Keep warm control key]
of the 2 zones A1, A2 or B1, B2 to be linked.
Automatic activation
Place a pot on the zones A1, A2 or B1, B2.
Increase the power
Glide your finger over the left slider until you
reach the desired power, both zones display the
chosen power.
Switch bridge function off
Simultaneously press [Keep warm control key]
of the 2 zones to be linked.
5.3.11 Grill function
This special cooking function optimises heating and warming
in a cast iron pot/grill plate. This will ensure improved results
of the food you are cooking. The zones A1 and A2 or B1 and
B2 will be automatically linked to one another using the bridge
function.
– 71 –
8
0
9
to
Bridge function:
Display
U
U
U
0
Display
0
0‐9
0
Advertenties
Hoofdstukken
Inhoudsopgave
