Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Boiled-over food should first be soaked with a wet cloth; the
contamination residues should then be removed with a glass
scraper that is specially designed for ceramic hobs. After this,
clean the hob as described under "Cleaning glass hob".
Burnt-on sugar and melted plastics are best removed
immediately – while still hot – with a glass scraper. After this,
clean the hob as described under "Cleaning glass hob". Grains
of dirt/sand may fall on the cooking plate while peeling potatoes
or washing vegetables and may cause scratches when moving
the pans. Therefore, ensure there are no grains left on the
surface.
Discolouration of the hob does not have any influence on the
operation or strength of the vitro-ceramic. It is not a form of
damage to the hob, but it is a result of residues that have not
been removed and have therefore burnt-in.
Shiny spots occur as a result of wear caused by the base of the
pans, in particular when using cooking pans with an aluminium
bottom or when using the wrong cleaning agents. These can
only be removed with great difficulty using common cleaning
agents. If necessary, repeat the cleaning several times.
Due to the use of aggressive cleaning agents and scratching
caused by the pan bases, the glass surface is rubbed off over
the course of time, leaving dark stains.
Do not use the cooking plate as a table top or for putting
utensils on.
Always lift up the pans/pots and do not slide them along the
glass plate.
9.2 Maintenance of the extraction hood
9.2.1 Cleaning after use
- Raise the extraction tower to its highest position, press
(several times) on
- Raise the uppermost glass from the extraction tower.
INFO: Do not place the top glass on a switched on
hob to avoid heating.
Clean with a damp cloth or sponge, use of a pH-neutral
detergent is possible. Wipe dry with a dry cloth/ kitchen paper.
- Tilt the front piece of glass using both hands and lift it out of
the extraction tower.
Clean the front and back of the glass with a damp cloth or
sponge, use of a pH-neutral detergent is possible. Wipe dry
with a dry cloth/ kitchen paper.
Press the
button after all parts are reinstalled.
Never use objects that could damage the glass such
as an abrasive sponge, abrasive cleaning liquid or
aggressive cleaning agents.
9.2.2 Cleaning the grease filters
When the grease filters must be cleaned, this is indicated by the
grease filter cleaning indication (see 4.5.1)
- Follow the steps described in 6.2.1.
- Take the grease filters out of the extraction tower (keep the
position of the grease filter in mind; there is a left and a right
grease filter)
Clean in dishwasher or immerse in hot water containing
degreasing detergent.
– 75 –
Advertenties
Hoofdstukken
Inhoudsopgave
