Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WARNING: If the instructions described above are
not followed, residue in the filter may cause a fire.
The uppermost extraction tower glass must NOT be
placed in the dishwasher. This may cause scratches
in the glass; it may also damage the coating on the
base.
After cleaning:
– Return the filters and the glass into the extraction tower.
– Press the
button after all parts are reinstalled.
– Press the
control key for 3 seconds.
9.2.3 Cleaning in the event of spillage into the device
- Follow the steps described in 6.2.1 and 6.2.2.
- Remove the upper collection containers from the tower and
clean if necessary.
- Remove the collection safety and clean if necessary.
- In the case of spillage of large quantities of fluid, slide the
lower collection containers from the underside of the extraction
hood and clean if necessary.
Follow the steps in the reverse order to make the device ready
for cooking again.
– Press the
button after all parts are reinstalled.
9.2.4 Cleaning the recirculation filter (only with
recirculation)
If recirculation has been selected, the device has been
connected to an built-in recirculation box with a recirculation
filter which can be regenerated.
Follow the cleaning instructions described in the
recirculation box / filter manual.
After cleaning:
– Return the recirculation filter into the built-in exhaust box.
– Press the control key
10 Troubleshooting minor faults
10.1 Messages on the hob
Code
– there is no cooking pan on the cooking zone
– the cooking pan is not suitable for induction
– the diameter of the bottom of the cooking pan
is too small when compared to the cooking
zone
See Chapter 5.3.9 Keep warm (1821)
U
– The electronic system is disrupted.
– Disconnect and reconnect the hob.
E
– Call the after-sales service
See Chapter 5.3.7 Stop & Go (1821)
I I
The controller keys are covered by liquid or an
item. The symbol will disappear as soon as the
(Er03)
keys are released or cleaned.
The hob has overheated, leave to cool, then
E2
switch back on.
The fan air supply is blocked.
E8
Unblock it.
The hob has not been properly connected to the
U400
network. Check the connection. (1821)
(Er47)
Problem in the device's internal bus system.
If one of these error messages remains visible, you can contact
the after-sales service.
The hob or the cooking zone does not work:
– the hob has been poorly connected to the electrical power
supply
– the safety fuse has blown
– check the locking key has been enabled
– the touch control keys have been splashed with water or fat
– there is an object on the touch control keys
– 76 –
for 3 seconds.
Advertenties
Hoofdstukken
Inhoudsopgave
