Inhoudsopgave
Advertenties
The protective guard (5) must only be able to be ro-
u
tated in the direction of the accessory while the ad-
justing lever (7) is actuated. Otherwise, the power
tool must not be used any more under any circum-
stances and must be sent to the after-sales service.
Operation
Starting Operation
Switching On and Off (see figure G)
To start the power tool, first press the lock-off switch (2),
then press and hold the on/off switch (1).
To switch off the power tool, release the on/off switch (1).
Note: For safety reasons, the on/off switch (1) cannot be
locked; it must remain pressed during the entire operation.
Status indicator
(see figure D)
The status indicator (21) indicates the status of the power tool according to the table below.
Status indicator (21)
Cause
Green
Power tool is ready for operation
Yellow
A battery with a capacity lower than 8.0 Ah is
used; the power tool can be used with reduced
power
Battery is almost empty
Power tool and/or battery are exceeding the
permissible operating temperature
Red (continuous) and LED
Power tool and/or battery have exceeded the
worklight flashing
permissible operating temperature
Power tool is being overloaded
Red (continuous)
Internal error
Battery is empty
Cutting disc is jammed
Flashing red, LED worklight
On/off switch was pressed while the battery
flashing and the power tool
was being inserted
does not start up
Bosch Power Tools
Opening/Closing the Water Supply (see figure H)
To open the water supply, put the valve (16) into position I:
Water will flow continuously over the diamond cutting disc.
To close the water supply, put the valve (16) into the OFF
position.
Switching On the Worklight (see figure I)
The worklight (19) will light up when the on/off switch (1) is
fully pressed. The worklight will remain lit for approx.
5 seconds after the on/off switch (1) has been released.
Overload protection
The power tool is equipped with an overload protection sys-
tem. In the event of overloading, the power tool automatic-
ally shuts off the electronics and the worklight (19) and the
status indicator (21) flash.
To switch the tool back on: Release the on/off switch (1).
As soon as the worklight (19) is no longer flashing and the
status indicator (21) lights up green, you can switch the
power tool back on.
Solution
–
Use a battery with a capacity of at least 8.0 Ah
Replace or charge battery
Run the power tool at no load and allow it to
cool down; allow the battery to cool down (see
"Technical Data", page 20)
Run the power tool at no load and allow it to
cool down; allow the battery to cool down (see
"Technical Data", page 20)
Replace the battery
End the overload state and, if necessary,
switch the power tool back on. Remove the bat-
tery and reinsert it. Then turn the power tool on
again
Remove the battery and reinsert it. Then turn
the power tool on again
Send the power tool to an authorised after-
sales service centre for Bosch power tools
Replace or charge battery
Release the on/off switch, remove the cutting
disc from the workpiece and restart the applic-
ation.
Release the on/off switch and continue insert-
ing the battery. Once the battery is fully inser-
ted, close the cover of the battery compart-
ment. Release the on/off switch (by pressing
the lock-off switch) and then press the on/off
English | 23
1 609 92A 3AM | (15.11.2024)
Advertenties
Inhoudsopgave
