Inhoudsopgave
Advertenties
•
Create islands by encircling obstacles, e.g. flower beds, with the boundary wire if you do not
want your robot to mow within this area. The incoming and outgoing wire must not be more
than 5 mm apart.
•
Stones can be approached by your robotic lawnmower without any problems if they are so
heavy that the robot cannot move them. However, if the stone has an inclined surface that the
robot could accidentally climb, you should remove the stone from the working area or place it
vertically with a minimum height of 15 cm.
•
If you have trees with roots protruding from the ground, these areas should be enclosed with
boundary wire to protect the trees. If there are no visible roots, no boundary wire is required.
•
If the boundary wire is laid under low-hanging branches of bushes or trees, you must cut back
the branches so that they do not obstruct the free movement of the mower. At the same time,
these branches can cause the rain sensor to activate if raindrops from the branches hit the
robot. In this case, the robot will return to the charging station even in dry weather (rain sensor
symbol is shown on the display).
•
If your driveway or garden paths are level with your lawn, your robotic lawnmower can easily
drive over them. If you want to avoid this, you only need 10 cm between the boundary wire
and the driveway. However, if your driveway is covered with gravel or similar, the robotic
lawnmower cannot drive over it. In this case, you need a distance of 30 cm between the
boundary wire and the driveway.
•
The robotic lawnmower is capable of travelling on slopes up to a maximum of 30°. If the surface
becomes steeper, the robot has a sensor that causes it to stop. If the surface slopes more than
25° towards the boundary wire, the robot may slip out of the working area when the grass is
wet. We therefore recommend laying the boundary wire up to 40 cm away from the boundary
line in such sloping terrain.
Manual_FX-RB224_Int24_rev1
36
Advertenties
Inhoudsopgave
