Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Note!
When installing, never hang the equipment by
the discharge line or by the power cable. The
equipment must be hung up by the provided carry
handle or suspension eyelet, or it must rest on the
bottom of the shaft. To ensure that the equipment
works properly, the bottom of the shaft must al-
ways be free of sludge and other accumulations
of dirt. If the water level is too low, the sludge
in the shaft can quickly dry out and hinder the
equipment from starting. It is necessary therefore
to check the equipment regularly (carry out trial
start-ups).
5.2 Mains connection
The equipment you have purchased comes with
an earthing-pin plug. The equipment is designed
for connection to a socket outlet with earthing
contact for 220-240 V ~ 50 Hz. Make sure that the
socket-outlet is suffi ciently fused (at least 6 A)
and in good working order. Insert the power plug
in the socket-outlet and the equipment is ready
for operation.
6. Operation
6.1 Using for the fi rst time
You can put the equipment into operation after
you have thoroughly read the installation and ope-
rating instructions. Pay attention to the following
points:
•
Make sure that the equipment is set up secu-
rely.
•
Check that the discharge line is fitted correct-
ly.
•
Make sure that the electrical connection is
220-240 V ~ 50 Hz.
•
Check that the electrical socket-outlet is in
good working order.
•
Make sure that no moisture or water can ever
reach the power connection.
•
Take care that the equipment does not run
dry.
Setting the On/Off switching point:
The ON/OFF switching point of the fl oating switch
can be adjusted by shifting the fl oating switch in
the fl oating switch notched holder (Fig. 1/Item 8).
•
The floating switch must be fitted so that the
switching point height: ON and the switch
point height: OFF can be reached easily and
with little force. Check this by placing the
equipment in a container filled with water
Anl_GE_DP_7535_N_LL_ECO_Flutset_SPK13.indb 17
Anl_GE_DP_7535_N_LL_ECO_Flutset_SPK13.indb 17
GB
and carefully raising and lowering the floating
switch with your hand. You can then see whe-
ther the equipment switches on and off.
•
Make sure that the distance between the floa-
ting switch head and the cable holder is not
too smaller than 10 cm. If the distance is too
small, there is no guarantee that the equip-
ment will work correctly (fig. 5).
•
When adjusting the floating switch, make
sure that the floating switch does not touch
the bottom before the equipment is switched
off. Important! Risk of dry running.
6.2 Shallow suction mode and dirty water
mode (Fig. 4)
6.2.1 Shallow suction mode (Fig. 4a)
•
Turn the equipment counter-clockwise and
press it to the bottom.
•
In shallow suction mode, water can be su-
cked up down to a level of 1 mm.
•
Only clear water can be pumped in shallow
suction mode.
6.2.2 Dirty water mode (Fig. 4b)
In dirty water mode the equipment can be set for
three diff erent sizes (15/25/35 mm).
•
Turn the equipment clockwise and pull it
upwards by the handle to the setting that you
require. Make sure that the locking screws
latch in place (B).
6.3 Manual operation:
Mount the fl oating switch as illustrated in Fig. 1.
The equipment will then run continuously. To pre-
vent dry running, this operating mode is allowed
only under supervision. The equipment must be
switched off (pull out the power plug) as soon as
no more water is emitted from the discharge line.
6.4 Using the pump as a fl ood kit (Fig. 6)
In order to operate the pump with the fi lter box
(12), the pump must be set to "Manual opera-
tion" mode (see section 6.3). Attach the woven
hose (11) to the quick-release coupling (10) on
the pump and lead it outward. To achieve maxi-
mum fl ow, avoid leaving kinks in the woven hose.
Now you can connect the pump power cable to
the power supply. The pump will start automati-
cally.
Note:
When operating the pump with the fi lter box,
please follow all the instructions for "Manual
operation" (see section 6.3). Mount the fl oating
- 17 -
28.10.2024 14:09:37
28.10.2024 14:09:37
Advertenties
Inhoudsopgave
