Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Pull the retaining bracket towards the front and keep it
4.
pushed upwards.
Fold the grill element upwards, until it clicks into place.
5.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side (figure A).
Pull the hook-in rack forwards at the rear and unhook to the
2.
side (figure B).
$
Faults and repairs
In the event of a fault, check the tips in the following table
before calling the after-sales service.
Problem
Electrical function is faulty (e.g. indicator
lamps do not light up)
Liquid or runny dough runs to one side
Appliance no longer works, ‹:‹‹ flashes in
the clock display
‹:‹‹ flashes in the clock display,
"rrr" appears in the temperature display
"E011" appears in the temperature display Permanent assignment of a button
The temperature display shows, "EXXX",
e.g. E300
Appliance operation is not possible, D
and -†- appear in the temperature display
Appliance operation is not possible, D
and -†˜ appear in the temperature display
The appliance does not heat up, the two
dots flash in the clock display, and ‚‡‹©
appears in the temperature display, for
example
Electronically controlled functions are mal-
functioning
42
%
Possible cause
Fuse defective
Appliance not installed level
There was a power cut
The power supply was interrupted while
the appliance was in operation
Internal fault in the appliance electronics
The appliance has been locked
The appliance controls were automati-
cally blocked
A button combination was actuated
Energy surges (e.g. lightning strike)
Clean the hook-in rack with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the indentation (a) facing
4.
downwards, so that the shelf heights match.
Insert the hook-in rack at the rear as far as it will go and push
5.
to the rear (figure C).
Insert the hook-in rack at the front as far as it will go and push
6.
downwards (figure D).
&
D
:
Risk of electric shock!
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Remedial action
Check fuses in the fuse box and replace if
necessary
Check the appliance installation (see
the Installation instructions)
Reset the time of day (see
section: Electronic clock)
Press the KJ clock function button. Reset
the time of day (see
section: Electronic clock)
Cancel the permanent assignment of the
button and press the KJ clock function
button
Press the KJ clock function button. If the
message does not go out, pull out the
mains plug and plug it back in again after
approx. 10 seconds
Deactivate the lock
(see section: Childproof lock)
Deactivate the permanent lock (see
section: Childproof lock)
Switch off the appliance, press and hold
the ± info button for 3 seconds, then press
and hold the KJ clock function button for
4 seconds, then press and hold the ± info
button again for 3 seconds
Reset the function concerned
'
D
Advertenties
Hoofdstukken
Inhoudsopgave
