Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Now measure the distance between the holes
found on the four wall brackets 2 (see fig.
D). These are the measurements for distances
between the holes to be drilled. Alternatively,
you can place the electric towel warmer in the
desired position on the wall and mark the loca-
tions of the holes to be drilled directly on the
wall through the holes in the wall brackets 2
(see Fig. E).
Please note the dimensions of the eight enclo-
sed dowels 8 before drilling. Drill the holes
(Ø 6 mm, 28 mm length) in the wall where you
would like to mount the electric towel warmer.
After the drill holes have been cleaned of any
dirt, insert the dowels 8 into the drill holes.
F
Please take care to mount the wall brackets 2
as shown in the illustration (see Fig. F).
Now secure the lower two wall brackets 2
with the supplied M4 x 30 mm Phillips screws
for attaching the wall brackets 2 .
10
G
Now place the electric towel rail in the newly
attached wall brackets 2 (see Fig. G).
H
Now position the upper two wall brackets 2
on the product and screw them to the wall as
well. Please take care to mount the wall brackets
2 as shown in the illustration (see Fig. H).
Notice: Ensure that the M4 x 30 mm Phillips screws
for attaching the wall brackets 2 are tightened
10
and that the electric towel rail cannot fall down.
This could lead to property damage and/or
personal injury.
4. Before start-up
Before the first start-up, check that the
mains voltage corresponds to the voltage
indicated on the device.
Please take care that the mains cable does
not become a tripping hazard. Always
route the power cable away from the rear
of the unit.
GB/NI/IE/CY/MT
11
Advertenties
Hoofdstukken
Inhoudsopgave
