Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operating the appliance
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Explanation
0
Fan off
1
Fan speed 1
2
Fan speed 2
Fan run-on
%
3
Fan speed 3
Intensive setting
g
Light on/off
A
Setting the fan
Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on
Press button 1, 2 or 3.
To confirm the setting, the 0 button and the set fan speed light
up.
Switching off the appliance
Press the 0 button.
Cleaning and maintenance
:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
Fan run-on time
The fan run-on is possible in any fan speed.
First, press the button for the required fan speed 1, 2 or 3.
1.
To activate the fan run-on, press and hold the % button for 2
2.
seconds.
To confirm the setting, the 0 button and the set fan speed
flash.
To end the fan run-on early, press the 0 button.
3.
Notes
The run-on time for all fan speeds is 30 minutes. Once this
■
time has elapsed, the ventilation and lighting automatically
switch off.
The fan speed can be changed during the run-on time.
■
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
To activate the intensive setting, press and hold the g button
1.
for 2 seconds.
To confirm the setting, the 0 button lights up and the g button
flashes.
To end the intensive setting early, press the 0 button.
2.
Note: The time of the intensive setting is 6 minutes. Once this
time has elapsed, the appliance switches back to the fan
setting that was previously set.
Lighting
The lighting can be switched on and off independently of the
ventilation.
Press the @ button.
Setting the brightness
When switching on the lights, press and hold the @ button for
2 seconds. The brightness is reduced.
Note: When switching on the lights again, the brightness is set
to maximum once again.
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use any of the following:
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.
11
Advertenties
Hoofdstukken
Inhoudsopgave
