Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Medication container
12
Mouthpiece
13
Nasal douche
Cover
20
Collection container
21
for nasal secretion
6. INITIAL USE
Setting up the device
Take the device out of the packaging.
Place the device on a flat surface.
Make sure that the vents are free from obstruc-
tions. Open the lid
2
atomiser set.
Before using the device for the first
time
Clean and disinfect the atomiser and atom-
iser set before using them for the first time.
See "Cleaning and maintenance" in this re-
gard.
• Connect the compressed air hose
bottom of the medication container
• Connect the other end of the compressed air
hose
to the nebuliser hose connection
8
turning it slightly.
• Insert the medication container
holder for the atomiser
Mains adapter connector
The device must only be connected to the mains
voltage that is specified on the type plate.
• Insert the mains plug of the mains cable
a suitable socket.
• To connect to the mains, fully insert the plug
into the socket.
• Ensure that there is a mains socket close
to the set-up area.
• Arrange the mains cable so that no-one
will trip over it.
• To disconnect the nebuliser from the
mains after inhalation, first switch o the
device and then pull the mains plug out of
the socket.
Angled fitting
18
Nasal douche
19
Saline container
22
Cover hole
23
to access the parts of the
8
.
12
A 2
into the
12
7
7. USAGE
Important
• For hygiene reasons, it is essential to clean the
atomiser
after each treatment and to disinfect them after
the last treatment of the day.
• The atomiser set parts may only be used by
one person; use by several people is not rec-
ommended.
• If the therapy involves inhaling several di er-
ent medications one after the other, please be
aware that the atomiser
der warm tap water following every usage. See
"Cleaning and maintenance" in this regard.
• Please observe the notes on changing the filter
in these instructions for use.
• Check that the hose connectors are firmly at-
tached to the nebuliser
before each use of the device.
• Before use, check that the device is function-
ing correctly. To do this, briefly switch on the
nebuliser (together with the connected atom-
iser, but without medication). If air comes out
of the atomiser
7.1 Inserting the atomiser insert
to the
• Open the atomiser
A 1
ticlockwise against the medication container
. Place the atomiser insert
12
by
6
cation container
• Ensure that the cone for administering medica-
tion fits well on the cone for the air duct inside
the atomiser
7.2 Filling the atomiser
• Fill with an isotonic saline solution or pour the
medication directly into the medication con-
into
1
tainer
12
ommended filling quantity is 8 ml.
• Use medication only as instructed by your doc-
tor and ask about the appropriate inhalation
period and quantity for you.
• If the prescribed quantity of medication is less
than 2 ml, top this up to at least 4 ml with iso-
tonic saline solution. Dilution is also necessary
with viscous medications. Here too, please ob-
serve the instructions of your doctor.
7.3 Closing the atomiser
• Close the atomiser
clockwise against the medication container
. Ensure that the connection is correct.
12
20
and the rest of the atomiser set
9
must be rinsed un-
9
and the atomiser
6
, the device is working.
9
by twisting the top an-
9
10
.
12
.
9
. Avoid overfilling. The maximum rec-
by twisting the top
9
9
in the medi-
Advertenties
Hoofdstukken
Inhoudsopgave
