Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Parts
See FIG. 1
A
Seal Button
G
Upper Foam Gasket
B
Vac/Seal button
H
Lower Foam Gasket
C
Accessory button
J
Extra Wide Sealing Strip
D
Store button
K
Vacuum Channel
E
Accessory Port
L
Removable Drip Tray
F
Lid Release Buttons
The user-friendly, intuitive control panel makes it easy for you to
get the most out of your FoodSaver
System:
®
1. Seal Indicator Light
Flashes when sealing process is engaged and becomes constant
when sealing process is finished.
2. Vacuum Indicator Light
Flashes when vacuum cycle is engaged and becomes constant
when vacuum cycle is finished.
3. Seal Button
This button has three uses:
1. Press to create a seal when making bags from a FoodSaver
Roll.
2. Press to immediately stop the vacuum process and begin
sealing the bag. This prevents crushing delicate items such as
bread, cookies and pastries.
3. Press to create a seal on multilayer film bags (such as a potato
chip bag) to keep food sealed airtight.
4. Vacuum Button
This button has two uses:
1. Press to vacuum seal food airtight. Motor will continue to run
until bag is fully vacuumed, then will automatically seal.
2. Press to pause vacuum process at any point.
5. Accessory Button
Press to use the Handheld vacuum Accessory Button.
Optional Accessories
Handheld Sealer use with FoodSaver
®
Zipper Bags and Fresh Containers, ideal
for fresh foods and snacks.
6
www.foodsavereurope.com
VS1290X_23MLM1 (EMEA).indd 6-7
VS1290X_23MLM1 (EMEA).indd 6-7
Make a Bag from a FoodSaver
®
See FIG. 2
1. Using scissors, cut enough bag material from roll to hold item, plus
3 inches. Be sure to cut straight.
2. Insert one end of bag material across Sealing Strip.
3. Press lid to lock. All lights will illuminate when the lid is fully locked
and ready to OPERATE.
4. Press Seal button.
5. When Seal Indicator Light stops flashing and becomes constant,
sealing is complete. Press lid release buttons to open lid.
Vacuum Seal with FoodSaver
Bags
®
See FIG. 3
1. Place item(s) in bag, allowing at least 3 inches of space between
bag contents and top of bag.
2. Open appliance lid and place open end of bag into Vacuum
Channel.
3. Press lid to lock. All lights will illuminate when lid is fully locked and
ready to OPERATE.
®
4. Press Vacuum button to begin vacuum and sealing process.
Motor will continue to run until bag is fully vacuumed, then will
automatically seal.
5. When Seal Indicator Light stops flashing and becomes constant,
press release buttons on both sides to open, lift lid and remove
bag.
NOTE: Let appliance cool down for 20 seconds after each use.
Important Tips:
To minimize bag waste, do not insert bags too far into the appliance.
Only insert bag just over the edge of the removable drip tray.
Vacuum Seal with FoodSaver
®
Accessories
See FIG. 4
1. Prepare container according to FoodSaver
Accessory Guidelines
®
(see manual that comes with your Accessory Kit).
2. Insert one end of the Accessory Hose into Accessory Port on
appliance until it clicks into place. Connect other end to the
accessory per Accessory Guidelines.
3. Press lid to lock. All lights will illuminate when the lid is fully locked
and ready to OPERATE. Press Accessory button.
4. When the light becomes constant, the vacuum process is complete.
Note that the appliance will still go through the sealing cycle when
vacuum sealing an accessory.
5. Remove Accessory Hose from accessory and appliance.
6. To test vacuum, simply tug on accessory lid. It should not move.
Roll
Use Handheld Sealer with Vacuum
Zipper Bags
See FIG. 5
Handheld sealer can be used with Vacuum Zipper Bags.
1. Fill zipper bag, lay flat with grey circle facing upwards. Squeeze air
out, zip 3/4 of the way closed and squeeze any remaining air out
before zipping completely.
2. Press Handheld Sealer over grey circle on bag and press
Accessory button.
Open FoodSaver
Accessories After Sealing
®
See FIG. 5
FoodSaver
Containers
®
To release vacuum and open, turn knob to open position.
FoodSaver
Bottle Stoppers
®
To release vacuum and open, twist and pull up on Bottle Stopper.
Care and Cleaning of your Vacuum
Sealer
To Clean Appliance:
Remove Power Cord from electrical outlet. Do not immerse in liquid.
Check Gaskets and around Drip
Tray to make sure they are free
from food materials. Wipe off Gasket
with warm soapy cloth if needed.
Upper and Lower Gaskets may be
removed for cleaning. Clean with
warm, soapy water.
The Removable Drip Tray makes
clean-up easy when small amounts of liquids are pulled into the
Vacuum Channel during vacuum process.
Empty Drip Tray after each use. Wash in warm soapy water or place
on top rack of dishwasher. Dry thoroughly before re-inserting into the
appliance.
To Store Appliance:
Clean unit thoroughly as detailed above.
After the unit has been cleaned and
allowed to fully dry, close lid without
locking and slide button to the Store
position. This setting prevents any
undue pressure from being applied
to the internal sealing gaskets of
the unit.
Never store lid in OPERATE
position as gaskets may become
compressed and the unit may not
function properly.
Store Vertically
Once in Store position, store
vertically to save valuable kitchen
space.
Fitting of a plug - for U.K. and Ireland
only
This appliance must be earthed.
If the plug is not suitable for the socket outlets in your home, it can be
removed and replaced by a plug of the correct type.
If the fuse in a moulded plug needs to be changed, the fuse cover
must be refitted. The appliance must not be used without the fuse
cover fitted.
If the plug is unsuitable, it should be dismantled and removed from
the supply cord and an appropriate plug fitted as detailed. If you
remove the plug it must not be connected to a 13 amp socket and the
plug must be disposed of immediately.
If the plug fuse requires replacement, a fuse of the same rating as
that fitted by the manufacturer must be used. In order to prevent a
hazard do not fit a fuse of a lower or higher rating
After sales service
In the case the appliance does not operate but is under warranty,
return the product to the place it was purchased for a replacement.
Please be aware that a valid form of proof of purchase will be
required. For additional support, please contact our Consumer
Service Department at: United Kingdom: 0800 028 7154 | Spain: 0900
81 65 10 | France: 0805 542 055. For all other countries, please call
+44 800 028 7154. International rates may apply. Alternatively, e-mail:
Plug should be ASTA approved to BS1363
foodsavereurope@newellco.com.
Fuse should be ASTA approved to BS1362
Green/Yellow
(Earth)
Blue
(Neutral)
Ensure that the outer sheath of
the cable is firmly held by the cord grip
Waste Disposal
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. E-mail us at
foodsavereurope@newellco.com for further recycling and WEEE
information.
www.foodsavereurope.com
Fuse
Brown
(Live)
7
2023/5/18 08:59
2023/5/18 08:59
Advertenties
Inhoudsopgave
