Advertenties
Beschikbare talen
Beschikbare talen
Specification
Data logging interval
Analog outputs
Relay
Sample and drain fittings
Controller rating
Controller power requirements 100 to 240 VAC ±10%, 50/60 Hz
1
Certifications
Warranty
Specification Details
Type
Exhaust gas cleaning system (EGCS) or scrubber wash water (freshwater or
seawater) with sodium hydroxide (NaOH), heavy fuel oil (HFO) and/or sodium
sulfate (Na
Pressure
6 bar (87 psig) maximum
Flow rate
60 to 180 L/h (nominal: 120 L/h); 1 to 3 L/min
Temperature
50 °C (122 °F) maximum
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
1
Certifications may be pending final review and approval. Certifications are subject to change
without notice.
2
Displacement of 1.0 mm peak at 2 to 13.2 Hz; sweep rate of 1 octave/minute maximum;
acceleration of 0.7 g at 13.2 to 100 Hz
4 English
Table 1 General specifications (continued)
Details
Conductivity: 15 minutes (default)
pH: 15 minutes (default)
PAH: 15 minutes (default)
Turbidity: 10 minutes (default)
One analog output for each measured parameter (pH, turbidity,
conductivity and/or PAH)
One alarm relay for low sample flow
½-inch ID fittings
IP66/NEMA 4X
DNVGL-CG-0339 Class A, except Class B for damp heat exposed
by vibrations from surroundings 1 mm/s
2
Class A
CE approved
UKCA approved
DNVGL-CG-0339
ClassNK
FCC/ISED SDoC - FCC Part15B/ICES-003, Class A
KC Mark
1 year (EU: 2 years)
Table 2 Sample requirements
SO
)
2
4
peak
(maximum) conform
Advertenties
Hoofdstukken
