Advertenties
Beschikbare talen
Beschikbare talen
_CombiPower_IA_DE-IT.book Seite 91 Freitag, 21. Oktober 2011 8:10 20
CombiPower
8
Switching the device on and off
NOTE
I
The main switch (fig. 1 10, page 3) on the device must be in the
"I" position.
➤ Press the "ON/OFF" button (fig. 3 2, page 4) on the remote control.
✓ The device is switched on and the message "System Initialisation ..."
appears in the display.
✓ After a few seconds, the display shows the message "System startup
please wait...".
The system status is checked.
✓ After 5 to 10 seconds, the display is ready and shows the status of the
device:
– The device is ready for use: the display shows operating parameters.
– Alarm messages are present: undervoltage, overload, fan failure,
overtemperature
– Faults have occurred: undervoltage (UVP), overvoltage (OVP), over-
temperature (OTP), overload (OLP)
9
Configuring the device with the
remote control
9.1
Basic information
Access to the "Another Param" menu, with which you can make the basic
settings, is password-protected. The default password is "0000".
Opening setup mode
➤ Switch on the device (see chapter "Switching the device on and off" on
page 91).
➤ Press the "
✓ You are now in setup mode.
EN
" button on the remote control for longer than 2 seconds.
Switching the device on and off
91
Advertenties
