Advertenties
Beschikbare talen
Beschikbare talen
_CombiPower_IA_DE-IT.book Seite 81 Freitag, 21. Oktober 2011 8:10 20
CombiPower
7
Connecting the device
7.1
Fastening the device
When selecting the installation location, observe the following instructions:
The device can be mounted horizontally or vertically.
The device must be installed in a place that is protected from moisture.
Do not install the device near flammable materials.
Do not install the device in a dusty environment.
The place of installation must be well ventilated. A ventilation system must
be present for installations in small, enclosed spaces. The clearance
around the device must be at least 25 cm.
The air inlet on the underside and the air outlet on the back of the device
must remain clear.
At ambient temperatures above 40 °C (for example in engine or heating
rooms, or direct sunlight), the device reduces the power to prevent itself
from overheating.
The device must be installed on a level and sufficiently sturdy surface.
Do not install the device in the same area as the batteries.
Do not install the device above batteries, because they can emit corrosive
sulphur fumes that will damage the device.
NOTICE!
A
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
Fasten the device as follows:
➤ Fasten the device with one screw through each hole in the holders.
EN
Connecting the device
81
Advertenties
