Advertenties
LIPROTEC-P Operating Instructions
Installing the LED module in the niche (W-LED)
Personnel
Protective equipment
Tool
After the niche has been durably connected to the mounting plate, the mounting profiles can
be tiled and the LED tube can be connected.
1. If necessary, adjust the intended position of the mounting profile "Adjusting the installa-
tion depth of the LED module" on page 65 .
2. Feed the feed-through cable into the mounting profile via the cable opening.
3. Embed the mounting profile in the adhesive.
4. Tile the mounting profile. In doing so, it is especially important to seal the feed-through
socket in accordance with the state of the art.
5. Press the LED tube flush with the end of the mounting profile and press it into the mount-
ing profile.
6. Establish the plug connection between the LED tube and the protruding feed-through
cable.
7. Press the LED tube lengthwise into the mounting profile. In doing so, feed the connection
cable and the plug connection into the feed-through socket via the cable opening and
push it completely into the feed-through socket.
> The full length of the LED tube is fully pressed into the mounting profile. The connec-
tion cable of the LED tube and the plug connection between the LED strip and the
feed-through cable are completely in the feed-through socket. The inserted LED tube
seals the cable opening from penetration by moisture.
Tiler
Protective gloves
Depending on the installation situation
EN
69
Advertenties
