Inhoudsopgave
Advertenties
Figure 29.
Vertical wall mounting
1. Place the bracket against the wall and mark
the eight holes. Make sure to place the
bracket upright, with the bracket openings
at the top.
2. Drill eight 10 mm holes at the marked
spots.
3. Place the anchor bolts
4. Tighten the wall bracket
pos. 1) to the wall with the eight nuts
(Figure
30, pos. 2).
5. Place the device brackets
3) over the wall bracket
6. Slide the device
openings of the wall bracket
pos. 1).
7. Make sure the control panel is located at
the bottom of the device.
8. To remove the device, lift and slide it in the
opposite direction.
(Figure
30, pos 3).
(Figure
30,
(Figure
31, pos.
(Figure
31, pos. 1).
(Figure
31, pos. 2) into the
(Figure
31,
Figure 30.
39
Advertenties
Inhoudsopgave
