Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WARNING!
Setting the power limiter should only be carried out by a registered and qualified installer. Please
read the safety regulations and the installation instructions carefully.
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds the
maximum available amount of power, the power is automatically reduced. The display of the cooking
zone who is being reduced in its power is first flashing; the level is then automatically reduced to
the highest available power.
The limiter is set at 7400 W by the factory, but it is possible to change it to 2800 W, 3500 W or 4500 W.
Power limiter configuration
Make sure there are no pots or pans on the hob before you start.
1. Disconnect the appliance from the main power supply by removing the power connector from
the socket, by removing the fuse or turning the circuit breaker off.
2. Reconnect the appliance to the power supply.
The keep warm key is flashing.
Perform, within 2 minutes after reconnecting the hob to the power supply, the following
steps.
Make sure all cooking zones are switched off.
3. Touch and hold the keep warm key.
4. Then, touch each cooking zone key counterclockwise (start with the cooking zone key on the
front right).
5. Release the keep warm key.
'C' is flashing alternately with '0' on the cooking zone display on the rear left.
The configuration value appears in the cooking zone display on the front left.
6. Touch the cooking zone key on the rear left and choose '8' by using the slide control.
'C' is flashing alternately with '8' on the cooking zone display on the rear left.
Power limiter
29
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
