Degree of protection
HG10141‑BS:
Product (except socket):
Socket:
dust protected/splash proof
1
splash proof
2
power plug for indoor use only
3
only when socket cover closed (without
4
power plug inserted)
only when socket cover closed
5
General safety instructions
BEFORE USING THE PRODUCT, PLEASE
FAMILIARISE YOURSELF WITH ALL OF THE
SAFETY INFORMATION AND INSTRUCTIONS
FOR USE! WHEN PASSING THIS PRODUCT ON
TO OTHERS, PLEASE ALSO INCLUDE ALL THE
DOCUMENTS!
m
WARNING! RISK OF DEATH
AND ACCIDENTS FOR
TODDLERS AND CHILDREN!
Never leave children unattended with the
packaging material . The packaging material
represents a danger of suffocation . Children
frequently underestimate the dangers . Keep the
product out of the reach of children at all times .
This product can be used by children from
8 years and above, and persons with reduced
physical, sensory or mental capacities, or
lacking experience and/or knowledge, if they
are supervised or have been given instructions
concerning use of the product in a safe way
and understand the hazards involved . Children
shall not play with the product . Cleaning
and user maintenance shall not be made by
children without supervision .
m
DANGER! Risk of suffocation! Children
could swallow and choke on small included
parts (e .g . screws) . Keep children away from
the work area during assembly .
8
GB/IE/NI
IP54
1, 3
IPX4
2, 5
This product does not contain any parts that
can be serviced by the user . The LEDs and the
built‑in control gear cannot be replaced .
If the LEDs fail at the end of their lives, the
entire product must be disposed of .
The power cord
cannot be replaced; if the
18 ]
[
power cord is damaged, the product shall be
disposed of .
Danger to life by
electric shock!
Always check the product for damage before
connecting it to the mains . Never use the
product if it shows any signs of damage .
Protect the power cord against sharp edges,
mechanical stresses and hot surfaces .
Always unplug the power cord from the socket
before installation, dismantling or cleaning .
Disconnect the product from the mains supply
if it is not going to be used for some time
(e .g . holiday) .
Prior to installation, verify that the mains
voltage on site corresponds with the operating
voltage required for the product (230 V∼,
50 Hz) . Otherwise do not install the product .
CAUTION! Risk of burn injuries! To
prevent burns, verify the product is switched off
and has cooled down for at least 15 minutes
before touching it . The product can become
very hot .
The accessible surface, especially heat shrink,
is very hot when the lamp is operating .
For HG10141, HG10141‑FR: The
power plug
can only be connected
[
18 ]
with a corresponding socket with the same
ingress protection (IPX4) in order to keep the
protective degree against dust/water .
For HG10141‑BS: Power plug for indoor
use only .
The product can be used on a flat, stable
surface, e .g . floor or table .
The product must not be used as a hand lamp .
m
WARNING! Risk of fire! Fit the
product so that it is at least 1 m away
from the material to be illuminated .
Excessive heat can result in a fire .