Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Installation instructions
8.
Screw in the screws for the appliance bracket
loosely; do not tighten them fully.
9.
Place the angle bracket for the flue duct on the
centre line so that it is flush with the ceiling.
Measure and mark the drill holes for the fastening
screws.
10.
Drill the holes.
11.
Insert the wall plugs flush with the wall.
12.
Screw on the angle bracket for the flue duct.
28
Preparing the appliance
▶
When starting up in air extraction, install the back-
flow flap, if required.
Installing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
ATTENTION!
If the glass flap is opened too far and the hinges over-
stretch, the appliance may be damaged.
▶
Do not push the glass flap upwards beyond the end
stop.
▶
Do not overstretch the hinges.
1.
Hook on the appliance.
2.
Open the glass flap.
Hold the glass flap at the lower edge and pull it
‒
upwards.
Slide the opened glass flap slightly to the rear.
‒
a The hinges click into place and the glass flap re-
mains open.
Advertenties
Hoofdstukken
Inhoudsopgave
