Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Application
Standard drilling
in wood, metal,
ceramics and plastic
˜ Tool-changing
Use the SDS-Plus tool holder
o
tools quickly and easily without the need for
any additional tools .
The SDS-Plus drilling tool moves freely
o
(depending on the system) . This leads to a
radial run-out deviation while idling . This has
no effect on the accuracy of the drill hole as
the drill centres itself during drilling .
The dust protection cap
o
the entry of drilling dust into SDS-Plus tool
holder during operation . Ensure that the dust
protection cap does not get damaged when
fitting tools .
NOTE
A damaged dust protection cap
u
be replaced immediately . Contact a
customer service workshop .
˜ Fitting an SDS tool
1 . Grease the SDS-Plus tool holder
with drill chuck grease
the tool .
2 . Insert the tool rotatingly into the SDS-Plus tool
holder
until it clicks into place .
[
12 ]
3 . Check that the tool is properly locked by
pulling it . The system has radial play because
of the design .
˜ Removing an SDS tool
Pull the locking collar
o
remove the tool .
14 GB/IE/NI
Tool
Appropriate SDS-Plus
drilling tool
to change
[
12 ]
largely prevents
11 ]
[
must
[
11 ]
slightly
12 ]
[
before inserting
[
20 ]
backwards to
[
13 ]
˜ Selecting operating mode
Press and hold the release button
o
mode selection knob
selection knob so that the arrow mark points
to the corresponding symbol .
Symbol
Operating mode
Drilling
Hammer drilling
Chiselling
Adjusting chisel position
Adjusting chisel position
In order to rotate the insertion tool to the required
position for chiselling, proceed as follows:
1 . Turn the mode selection knob
(adjusting chisel position) .
2 . Turn the insertion tool in the SDS-Plus tool
holder
into the required position .
[
12 ]
3 . Turn the mode selection knob
(chiselling) .
˜ Setting the rotation direction
NOTE
Operate the rotation direction switch
u
only when the product is at a standstill .
Use the rotation direction switch to change
o
the direction of rotation of the power tool . This
is not possible while the on/off switch
pressed in .
Clockwise: Push the rotation direction switch
o
to the left as far as the stop .
Anti-clockwise: Push the rotation direction
o
switch to the right as far as the stop .
on the
8 ]
[
. Turn the mode
9 ]
[
to
9 ]
[
to
[
9 ]
2 ]
[
is
3 ]
[
Advertenties
Hoofdstukken
Inhoudsopgave
