Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Switching on/off
Insert the mains plug
o
The LED
lights up to indicate that the
[
6 ]
product is ready for use .
Switching on
Press the on/off switch
o
Do not switch the power tool on unless you
o
plan to use it, to save energy .
Switching off
Release the on/off switch
o
At low temperatures, the power tool will only
o
reach its full hammer performance/strike
power after a certain time .
Continuous operation
Press the on/off switch
o
press the lock button
switch .
To cancel continuous operation, press the on/
o
off switch
and release it .
[
3 ]
˜ Selecting rotational speed
NOTE
The set speed is only reached in continuous
u
operation .
Rotate the speed selection wheel
o
the rotational speed from level 1 (low) to level
6 (high) . The required speed depends on the
material to be processed .
˜ Troubleshooting
Problem
Possible
cause
The product
The motor is
does not
defective .
work .
into a socket-outlet .
5 ]
[
.
3 ]
[
.
3 ]
[
. At the same time,
3 ]
[
to lock the on/off
4 ]
[
to select
7 ]
[
Solution
Have the
product
repaired by
a qualified
specialist .
Problem
Possible
cause
The
Excessive
performance
pressure on
of the
the product .
product is
poor .
The drill
chuck grease
is used up .
˜ Cleaning and maintenance
m
WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments, cleaning and when not
in use .
˜ Cleaning
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces .
Never allow fluids to get into the product .
u
The product must always be kept clean, dry
u
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help
u
ensure safe use and prolong the life of the
product .
Clean the product with a dry cloth . Use a soft
o
brush for areas that are hard to reach .
In particular clean the air vents after every
o
use with a cloth and soft brush .
The air vents must always be clear .
Solution
Apply
appropriate
pressure to the
product .
Lightly grease
the SDS-Plus
tool holder
12 ]
[
with drill chuck
grease .
GB/IE/NI
15
Advertenties
Hoofdstukken
Inhoudsopgave
