Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation and startup
Notes:
1.
2.
3.
5.3.1
Connection to the public grid (AC)
Attention !
You must safeguard each inverter with an individual AC breaker so that the inverter
can be safely disconnected under load.
Connect AC wires with the inverter via the AC female connector. Please follow the procedures listed below:
1.
Switch off the AC breaker and secure against being switched back on accidentally.
2.
Strip the cable 7mm.
3.
Open the AC female connector and connect the wires (three wires: L, N and PE) as shown in the figures
below. Insert the striped cable wires (L, N and PE) into the corresponding three holes of the AC female
connector. The polarity of each hole is signed. Please note that wire L must be connected to the hole L,
wire N to the hole N and wire PE to the hole signed :
All manuals and user guides at all-guides.com
After the inverter has been mounted in its fixed position, the electrical
connection to the unit can be established.
Choose the appropriate cable model for AC wire (AWG 10, 4mm
wire (AWG 12, 2.5 mm
To ensure safety before the inverter is totally installed, the AC and DC end
must be disconnected from all power sources.
2
).
. Then fully tighten all screws.
18
2
) and for DC
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
