Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation and startup
5.2 Installing the inverter
Installing procedure:
The installation must comply with local regulations and technical specifications.
a) Drilling holes
Use the holes in the mounting panel to select the correct drilling position. The
space between every two holes is shown in the figure on the right. Drill four
holes at the selected installation position. Avoid tilting the holes. The depth of
the holes must be the same and within the range of 55 - 60 mm.
Attention!
Before inserting wall plugs, measure the depth of every hole and the distance
between every two holes. If the measure values do not meet the installing
requirements, re-drill holes in the wall.
b) The screws
After drilling holes in the wall, place the four wall plugs (object 2 shown in the drawing below) in the holes using a
rubber hammer. Then, screw the four self-tapping screws (object 1 shown in the drawing below) into the wall plugs.
All manuals and user guides at all-guides.com
15
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
