Advertenties
Beschikbare talen
Beschikbare talen
7. SECURING THE SAFETY NET
STEP 13
Note
The zip fastener (11a) on the safety net (11) must be closed.
Note
They must CLICK audibly when being fastened. This indicates that the pin of the net poles with holder (4) is correctly
locked into the pin hole of the net pole (3).
1. With two people standing opposite one another, lift the safety net (11) onto the net poles with holder (4) and
place the end of the net poles with holder (4) on the ends of the net poles (3).
STEP 14
Note
The zip fastener (11a) on the safety net (11) must be closed.
Note
Start by threading the first cord (14) near the entrance of the safety net (11).
Note
The holes in the safety net (11) should be evenly spaced and halfway between the eyelets (7a).
1. First attach one end of a cord (14) to an eyelet (7a) near the entrance.
2. Then thread the other end of the cord (14) between the first and second eyelet (7a) from the outside inwards
through two holes in the safety net (11).
3. After the second hole, guide the cord (14) from the bottom upwards through an eyelet (7a) in the jump mat (7).
4. Pull the cord (14) taut.
5. Thread the cord (14) back through two more holes in the safety net (11) and an eyelet (7a) of the jump mat (7)
from the outside inwards.
6. Pull the cord (14) taut.
7. Repeat steps 5 and 6 until you only have a short length of cord (14) left.
8. Fasten the end of the cord (14) with a simple knot.
9. Thread the other cords (14) as described above until you have secured the entire safety net (11). Knot the loose
end of the last cord (14) as close as possible to the eyelet (7a) where the beginning of the first cord (14) is
attached.
24
GB/IE/NI
Advertenties
Hoofdstukken
