Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.2 Area of application: The user environment
This wheelchair has been designed to accommodate both
indoor and outdoor use (EN12184 (2014) Class B). When
driving the wheelchair outdoors, drive only on paved roads,
pavements, footpaths and bicycle paths. The speed must be
adapted to suit the environment.
WARNING!
• Drive carefully on slippery roads resulting from rain, ice or
snow!
• You are required to turn on the lights in case of limited
visibility.
• When driving at higher speeds you must be extra careful.
Select a lower maximum speed indoors, on the pavement
and in pedestrian areas.
• Do not drive off high obstacles.
• Do not attach a weight to the wheelchair without the
approval of a qualified specialist. This may negatively affect
the stability of the product.
CAUTION!
• Prevent the wheelchair from coming into contact with sea
water: sea water is caustic and may damage the wheelchair.
• Prevent the wheelchair from coming into contact with sand:
sand can permeate into the moving parts of the wheelchair,
causing extensive wear on these parts.
• Do not use the wheelchair if temperatures are below: -25˚C
or above +50˚C.
• Do not open doors using the leg rests.
• Do not push and/or tow any objects with the wheelchair.
• Do not drive through puddles of water.
Q400 M/F/R | Rev. J | English
4.0 Setting up the wheelchair
Sunrise Medical wheelchairs can be adjusted according to
specific needs of the user.
In this, we make a distinction between wheelchair settings and
wheelchair seating adjustment options. Settings are carried
out once, the first time the wheelchair is going to be used.
They must be executed by qualified specialist, unless explicitly
stated otherwise. Seating adjustment options can be carried
out by the user. These adjustment options do not require the
use of tools.
4.1 Seating system
The extensive settings with respect to the seating system allow
for optimum support of the body (& Seating system). The
following setting options are possible:
1. Seat depth and seat width
2. Backrest angle
3. Armrest height/width
4. Lower leg length
5. Angle of the footplate
6. Legrest angle
4.2 Seat height
Depending on the specific circumstances of the user of the
wheelchair the seat height can be set. Every optional seat
height lies within the rated slope as described in EN12184
(2014) Class B. Lowering the seat height has a positive
influence on the (dynamic) stability.
WARNING!
Increasing the seat height has a negative effect on dynamic
stability.
4.3 Centre of gravity
DANGER!
Adjusting the centre of gravity on a powered wheelchair is
both physically demanding and safety critical. Sunrise Medical
recommends that this adjustment is only performed by a
service agent/dealer approved by Sunrise Medical.
4.4 Controller height and depth
(& Seating system).
4.5 Control system programme
This wheelchair is equipped with a control system that can be
programmed by adjusting settings within the system. This is a
specialized job that needs training and can only be adjusted
with professional software. The end user is not allowed to
adjust these settings.
DANGER!
The incorrect setting of the parameters for the control system
may result in very dangerous situations.
Settings must be made by qualified specialists.
Fig. 3.2
11
Advertenties
Hoofdstukken
Inhoudsopgave
