Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation and Operation
TAS-UNI
V4
4.3
Adjustment of roller unit (Alu-Profile)
The working height of the device (TAS-UNI) can be
adjusted with the spindle (1).
●
Place the alu-profile direct on the facing bedding sand
(see fig.4).
●
Place the roller unit on the alu-profile.
●
Release the eyebolt (2).
●
Adjust the screeding profile on the crank (1) in that
way, that the screeding profile rests on the facing
bedding sand. Orientaion on the scale (3).
TIPP Optimal facing bedding sand (grit height) 2-3
cm.
●
Fasten eyebolt (2) again.
IMPORTANT
Roller unit
Alu-Profile
Facing bedding sand
m
(1)
(2)
(3)
Fig. 3
Roller unit
Facing bedding sand
Alu-Profile
Alu-Profile must rest on the
facing bedding sand.
Fig. 4
12/06/18
13 / 18
Alu-Profile may not sink in the
facing bedding sand!
Advertenties
Hoofdstukken
Inhoudsopgave
