Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation and Operation
TAS-UNI
V4
4.1.1
Adjustable Adapter for Roof-/Pan Profile
●
With the adjustable adapter TAS-DP (2000 mm) any
roof or pan profile can be adjusted (+/- 4 % with scale)
to prepare any roof or pan profiles.
●
Screw the nuts on the inner side at the TAS-DP
slope (%) for roof profile Figure 2 (see also Figure A
on following page).
Screw the nuts on the outer side at the TAS-DP
slope (%) for pan profile Figure 3 (see also Figure B
on following page).
Figure 1
4.1.2
Adjustment roof profile
Loosen both nuts (2) on the outer side at the TAK-DP. Figure 1
Adjust the slope (e.g. 1%) with the both nuts (3) on the inner side at the TAK-DP. Figure 2
Slope (e.g. 1%) is viewable and adjustable on the scale (4) and indicator (5). Figure 3
1 scale line on the scale (4)
The indicated slope (%) on the scale is only for orientation.
The actually slope (%) must be measured again unconditional on the facing bedding sand!
See Figure A und A1 on the following pages.
Figure 1
(2)
≙
0,5 % slope. Figure 3
≙
≙
Adapter for roof-/and pan profile
Figure 2
Figure 2
(3)
(3)
Figure 3
Figure 3
(5)
12/06/18
8 / 18
(4)
Advertenties
Hoofdstukken
Inhoudsopgave
