Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
40
www.electrolux.com
6. SETTINGS
6.1 Programme selection mode
and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
according to the water hardness.
• The activation or the deactivation of the
acoustic signal for end of programme.
These settings will be saved until you
change them again.
6.2 The water softener
German de-
grees (°dH)
>24
18 - 24
12 - 18
4 - 12
1) Factory setting.
2) Do not use salt at this level.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
flash and the display is blank.
2. Press
• The indicators
• The indicator
flash.
• The display shows the current
setting: e.g.
Water hardness
French de-
grees (°fH)
>40
32 - 40
19 - 32
7 - 19
<4
<7
,
and
.
and
continues to
= level 5.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows 2 horizontal
status bar.
When you activate the appliance, usually it
is in programme selection mode.
However, if this does not happen, you can
set the programme selection mode in the
following way:
Press and hold Reset until the appliance
is in programme selection mode.
mmol/l
>4.2
3.2 - 4.2
2.1 - 3.2
0.7 - 2.1
<0.7
3. Press
4. Press the on/off button to confirm the
6.3 Acoustic signals
Acoustic signals sound when a
and
until
malfunction of the appliance occurs. It is
start to
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
go off.
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to activate
it.
Clarke de-
Water softener
grees
28
22 - 28
13 - 22
5 - 13
< 5
again and again to change
the setting.
setting.
level
5
4
1)
3
2
2)
1
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
