Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Bridge induction ('SV' and 'SVI' models)
Switching off
EN 18
The Bridge induction zones can be linked to each other. This creates
one large zone that can be used, for example, for the ATAG grill plate,
the ATAG teppanyaki, a large fish pan or various pans on the same power.
• If the Bridge induction zones are linked, they cannot be set to boost
and the menu functions cannot be used.
• Use a fish or other pan that covers at least one of the Bridge
induction zones in the middle.
Switching on bridge function
1. Place the large pan on both cooking zones so that these are both
well covered.
2. Switch the front cooking zone on.
3. Press on the bridge function key of the front slide control for two
seconds in order to set the status 'bridge'.
'BR' will appear in the display on the rear zone. The rear zone can
no longer be used.
4. Slide with your finger over the front slide control (clockwise) or tap
with your finger on the slide control to set the desired setting. Both
zones are heated to the level set.
Switching off bridge function
1. Press on the bridge function key of the front slide control for two
seconds in order to switch off the status 'bridge'.
The bridge function is switched off, the rear display goes off,
level 1 is present in the front display.
Or:
2. Press on the on/off button of the front cooking zone in order to
switch both zones off.
You will hear a signal and the level in the display disappears. The
cooking zone has been switched off completely.
Switching off one cooking zone
Press the on/off button of the cooking zone you want to switch off.
You will hear a single signal and the slider goes off.
• If all cooking zones have been switched off in this way, the hob
will automatically be in the stand-by mode (also refer to 'stand-by
mode').
Advertenties
Hoofdstukken
Inhoudsopgave
