Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Switching on and power setting
Automatic pan detection (APd)
EN 16
1. Press the key button.
A single audio signal sounds.
2. Place a pan in the middle of a cooking zone.
The APd registers a pan and a flashing '-' appears in the display.
If you don't do anything else, the cooking zone will switch off
automatically after 10 seconds.
3. Slide with your finger over the slide control (clockwise) or tap with
your finger on the slide control to set the desired setting. The
cooking zone starts automatically at the setting that has been set.
4. Set a higher or lower power by sliding with your finger over the slide
control or by tapping the slide control. The cooking zones have 12
settings. There is also a 'boost' setting for the induction zones.
Please note!
If the APd function is switched off, activate a cooking zone using the
on/off button.
Once the hob is switched on, if a pan is placed on an inactive cooking
zone, the corresponding control will light up and can be operated
immediately (without operating the on/off button). If the cooking zone
is not switched on within 10 seconds it will switch itself off again. The
cooking zone can be reactivated by removing the pan and replacing it
on the cooking zone or by using the on/off button.
Switching the APd on and off
This function is active as standard, but can also be disabled.
Disable the function by switching off the hob. Then from the Eco stand-
by mode operating the 'Pause' button (1) for 5 seconds. The display
will read 'APd OFF'. By repeating this action, the function will be
reactivated and 'APd On' will appear in the display.
Pan detection
If the hob doesn't detect a(n) (iron-containing) pan after a cooking
power has been set, the display will continue to flash and the cooking
area remains cold. When no (iron-containing) pan is placed within one
minute, the cooking zone will switch off automatically.
Advertenties
Hoofdstukken
Inhoudsopgave
